Crane Boom Repair SOW.pdf

STATEMENT OF WORK

FOR

CRANE BOOM REPAIR

AT

MINOT AFB, ND

1.0. INTRODUCTION. This Statement of Work (SOW) defines the requirements for the contractor to repair the damaged crane boom cylinder and components. The contractor will restore the crane boom assembly to fully operational status on one 2010 Peterbilt 365 (Serial Number: 1NPSXUEX5BD118017, US Air Force Registration Number: AF10D00653). Specifically, the contractor is required to rebuild the leaking main boom cylinder by replacing all seals and any damaged or unusable internal components.

Furthermore, the contractor will replace the boom wear pads, lubricate all specified boom lubrication points, and replace any damaged or unusable hydraulic lines and hoses as necessary to ensure safe, mission-ready operation.

2.0. SCOPE. The contractor will provide all materials, labor, management, transportation, and other incidentals necessary to meet the requirements as stated in this SOW. Materials provided are to be brand name or equal and must be new and not refurbished.

2.1. Replacement/Repair. The Contractor will perform an overhaul of the Boom Assembly, which specifically entails a complete Main Cylinder Rebuild. This process requires rebuilding the boom cylinder by replacing all seals and any other unusable internal components. Additionally, the contractor must conduct a Wear Pads Replacement by installing new boom wear pads and ensuring the inner boom pads are thoroughly lubricated. The contractor is required to inspect the system and replace all hoses, hydraulic lines, and lubrication points as needed to restore the assembly to optimal and safe operational status. Final testing of the product must be accomplished as required by the manufacturer’s specifications. All salvageable or unused parts identified will be transferred to the government vehicle custodian.

2.2. Transportation. All work will be performed at the contractor’s facility. The Government assumes full responsibility for transporting the equipment to the contractor's site and retrieving it upon completion of the service, provided the contractor's repair facility is located within a 130-mile radius of the dispatching installation. Contractor locations exceeding this 130-mile limit will not be eligible for Government-provided transport. To ensure smooth logistics, the contractor must coordinate the specific drop-off and pick-up dates with the designated Government Point of Contact (POC) at least seven (7) days prior to the commencement of work.

3.0. GENERAL REQUIREMENTS.

3.1. Waste Disposal. The contractor will dispose of waste to include unserviceable parts from this project off base and IAW Federal, State, local, and base environmental laws, and regulations.

3.2. Fire Suppression. Any new wiring or hosing shall use adequate fire blocking to meet or exceed the current standard in place.

3.3. Installation Access. A current REAL ID-compliant driver’s license, state-issued identification card, or U.S. passport, and a current automobile insurance document and vehicle registration will be required to a to gain access to Minot AFB.

3.3. Installation Access. A current REAL ID-compliant driver’s license, state-issued identification card, or U.S. passport, and a current automobile insurance document and vehicle registration will be required to a to gain access to Minot AFB.