Paint Barn Q and A.docx
DOCX document 15 KB Posted
- Attached to
- Paint Barn
- Solicitation number
- F3CTMG5120AW01
About this file
This document is a Questions and Answers (Q&A) file for a Paint Barn project at Minot Air Force Base, involving the installation of an industrial semi-down draft spray booth. The Q&A addresses technical specifications and project logistics, including equipment requirements such as nut and bolt assemblies, booth dimensions, utility needs, and environmental considerations. Key details include a preferred heater temperature range of 80-130 degrees, fire suppression lines to be installed outside the booth, and a preference for low humidity.
The project involves the Department of the Air Force Global Strike Command, with flexibility on project timeline and a potential longer Period of Performance (POP) due to equipment lead times. The government will handle hazardous material disposal through their normal waste stream and is open to winter installation. Specific technical inquiries were made about electrical disconnects, compressed air, natural gas capacity, and potential hexavalent chromium abatement, with some details to be confirmed by Base Civil Engineering (CE).
View the file
Other files
| File | Type | Posted |
|---|---|---|
| Paint Barn Q and A.docx | DOCX document | |
| Combo-Paint Barn-Final.pdf | ||
| MFR Site Visits - Paint Barn.pdf | ||
| Combo-Paint Barn-Final.pdf | ||
| SOW - 91st Paint booth.docx | DOCX document |
On GovTribe
Work with this file
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
Paint Barn Questions and Answers (last updated 08/11/25)
Q: Nut and bolt assembly: Is this required or will the gov’t consider self-tapping?
A: Prefer nut/bolt. If tapped bolt hole elongates, hard to replace for seals Q: Can you please send all dimensions of the space for the paint booth, including total height availability in the area. Are there any obstructions to be aware of? Are the booth dimensions in section 2.0 are the same as the booth they currently have, or are the requested dimensions different from what they already have?
A: All dimensions are current build Q: What utilities are available for the current paint booth that will need to be tapped into for the new booth. Can you provide total capacity at each electrical disconnect, compressed air, and natural gas?
A: This would have to come from Base CE Q: Will the area need to be abated of hexavalent chromium prior to installation of the new booth? Would you like the contractor to take care of this prior to installation?
A: I don’t believe so, but they can test for certainty Q: Are fire suppression lines to be installed inside the booth or above the booth?
A: Outside of booth Q: What is the desired target temperature (or range) for the heater to provide based on application of coatings?
A: 80-130 degrees Q: Are there any humidity control requirements to be aware of?
A: As low as possible Q: Prior to the government disposing of the old booth, should the vendor make plans to palletize or strap together the old equipment, or will the government provide roll-offs for the disposal of old equipment and filters?
A: Filters will be removed by our shop. Rolloff can be scheduled Q: Will the government dispose of any potential hazmat through their normal waste stream?
A: Yes Q: Is this a funded project, and do you anticipate installation in the winter months?
A: Winter would be best time if possible Q: Is the government amenable to a longer POP? Depending on the time of award, lead times on AMUs and supporting equipment can be longer than 120 days A: Yes
File details come from the government source that posted it. Updated .