B08_Atch_1_-_Statement_of_Work.pdf

Lake Mead National Recreation Area

Boulder City, Nevada

Equipment Repair Services:

Caterpillar 440F2 Backhoe

DATED: 3/19/2025

Prepared By: Trent Martinez, Supervisory Facility Management Systems Specialist

NATIONAL PARK SERVICE

Lake Mead National Recreation Area

LAKE – Equipment Repair Services

EQUIPMENT REPAIR SERVICES – 440F2 BACKHOE

1. BACKGROUND

Lake Mead National Recreation Area (LAKE) is a U.S. National Recreation Area in Southeastern Nevada and Northwestern Arizona. Operated by the National Park Service, Lake Mead NRA follows the Colorado River corridor from the westernmost boundary of Grand Canyon National Park to just north of the cities of Laughlin, Nevada and Bullhead City, Arizona. A fleet of heavy equipment is utilized to maintain park operations across the recreation area.

This contract requires repairs services for the NPS owned fleet of heavy equipment operated by the maintenance staff to perform critical maintenance operations.

2. REQUIREMENTS

The Lake Mead Staff will transport the equipment to the contractor’s shop location. The shop must be located within 100 miles of the Lake Mead Maintenance complex. The contractor shall complete the repairs and contact the Contracting Officer’s Representative (COR) to set up a time for an onsite inspection. Once the work has been accepted by the COR, Lake Mead staff will transport the equipment back to the Park.

Address of Lake Mead Maintenance Complex:

101 Katzenbach Drive, Boulder City, NV 89002

Equipment: Caterpillar 440F2 Backhoe

Repairs Required: Contractor shall provide all labor, tools, and parts necessary to complete, test, and calibrate to assure original equipment manufacturer’s functionality of the following repairs:

a) Replace all the leaking hydraulic hoses, clamps, seal-o-rings, and lines at the bottom of the hydraulic tank next to the cab that are leaking.

b) Repair, test, check, and adjust the bucket linkage positioning sensor to manufacturer specifications.

c) Repair, straighten, and recondition to stop all hydraulic leaks on the left and right rear stabilizer cylinders.

d) Repair, straighten, and recondition to stop all hydraulic leaks on the rear boom cylinder.

e) Repair, straighten, and recondition to stop all hydraulic leaks on the stick cylinder.

f) Repair, straighten, and recondition to stop all hydraulic leaks on the multipurpose bucket cylinders with a level 1 reconditioning including replacement of internal seals and gaskets.

g) Replace product link system wiring harness and antenna.

LAKE – Equipment Repair Services

h) Replace cabin roof panel including the power outlet and wiring harness on front right hand top corner and roll over protection system.

i) Refill all hydraulic fluids and fluid reservoirs to manufacturers recommended levels and perform a fluid analysis.

j) Contractor shall test all hydraulic lines after installation to ensure no leaks exist.

Only the work covered in this document shall be completed unless otherwise authorized by the contracting officer. If additional issues are found, the contractor must stop work and contact the contracting officer for further guidance.

3. PERIOD OF PERFORMANCE:

All tasks and deliverables for this contract must be completed within 40 of days after award.

Days listed herein refer to calendar days.