Attachment 2-Salient Characterics dated 14 May 24.pdf

353 SWTS

UH-60 Helo Training Simulator Specifications

The UH-60 T is a portable, reusable simulated aircraft cabin structure built for providing realism to combat training without heavy demand on live aircraft and personnel. It provides the capability to train appropriate personnel on the proper methods of Infil and Exfil of equipment/personnel during routine, hot, and emergency operations from the interior of a simulated aircraft within the parameters of a training exercise.

Configuration

• Allows for combat configuration of equipment

• Allows for two fire teams (8 personnel)

• Allows for realistic military Infil and Exfil training

• Allows for connection for standard TACP Comms in a configuration they will utilize in the field

• Allows for muscle memory training for operation of harness assemblies during Infil and Exfil conditions i.e., routine, hot, and emergency scenarios

• Provides realistic environmental conditions noise/wind/smoke

The UH-60 T trainer has the following features: nosecone, front window left center and right window, dual side gunner window, functional dual sliding doors with windows, main control and generator compartment and external radio antennas.

Interior includes a pilot and co-pilot dash with manual controls, custom center cabin two row (back-to-back mounted) folding seats (8 total included), floor tie down rings, 4 red rings, aft wall tie down rings.

Simulator is a mobile DOT licensed trailer built with characteristics of a UH-60 aircraft. Local trailer licensing may apply.

Nose, interior floor and ceiling, roof and rear component storage unit are spray lined with non- slip and waterproof coating. Interior and exteriors walls, doors, trust, and under carriage are primer sealed, with two coats of acrylic enamel finish.

UH-60 T Frame construction

• Simulator length: 25 feet length

• Simulator width: 102 inches

• Floor width 72 inches, mid-section width 84 inches, and ceiling width 69 inches

• 5 x 2 tube 11-gauge box frame rails

• 3 x 2 tube 11-gauge cross members

• 12-gauge steel floor with UH-60 Tie down 1,500 lbs.

• 14-gauge fabricated I beams

• 00.50 aluminum siding

• 4 ceiling red rings located at the corner of the sliding crew door 2,000 lbs. (red rings)

• Pilot and Co-Pilot doors with reinforced hinged doors

• Steel frame doors

502 CONS/JBKAE

JBSA Lackland, TX 14 May 2024

F2MTRF4113AW01

UH60 Training Simulator

Attachment 2 1 of 9

• Window with locking doors

• Dual left and right sliding crew door

• Dual steel sliding rear door

• Each door has two windows

• Doors can be locked manually (closed position)

• Emergency rear window door release

• Side gunner windows located between pilot and sliding crew door and co-pilot and sliding crew door.

• Windows open and close

• Windows lock in the closed position

• Control unit operation compartment located at the aft end of the trailer

• Dual hinged reinforced locking doors

• NARS Sensory Control Unit (SCU) with shock absorber mounting unit

• Self-powered via generator with proper exhaust

• Inside dimensions: 18 feet length x 72 inches width x 54.5 inches in height

The remote-controlled unit (Sensory Control Unit) is a custom designed interface operated via NARS tablet. The SCU unit can easily be removed from trailer. NARS Sensory Control Unit allows for an increase/decrease in the level of stress on the trainee via the control of environmental factors, including light, beacon, noise, wind, smoke, and other specialized components.

NARS Sensory Control Unit Operating Software is an Android-based software package that was created to accompany CASEVAC Trainer to give instructors the ability to control the physical responses light, noise, beacon, wind, and smoke from .5 miles.

The easy-to-navigate, touch-screen menu options, allow modify light, noise, wind, smoke, beacon, and audio sound system range of .5 miles and monitor live video through IP cameras from 300 feet away through included NARS tablet.

Status information on each of the physical components and the status of the communication link is graphically displayed in the CASEVAC control screen.

To assist in post-training review, the camera control captures through picture and or video. Images collected throughout the training experience can be viewed in the Android gallery and downloaded from the camera control folders after the training is complete.

Wireless network System

• High speed 300Mbps 802.11 b/g/n wireless networking

• Features multiple operating modes and power over Ethernet

• Setup utility allows for easy configuration of multiple outdoor access points

• Heavy duty, weatherproof design

• 2 x external 5dBi high gain omni-directional antennas. POE powered switch.

• All these functions are controlled by a single water-resistant NARS operating unit

Remote control via NARS Instructor tablet for controlling wind, smoke, cabin lights, beacon, camera, and noise. The unit allows for remote controlling up to .5-mile line of site. Communications are via X-Bee relay system that utilizes a low frequency, point-to-point linkage that does not interfere with real-world avionics, weapon systems, telemetry, etc. Detailed communication information available upon request.

502 CONS/JBKAE

JBSA Lackland, TX 14 May 2024

F2MTRF4113AW01

Attachment 2 2 of 9

Rotor wash

• Remotely controlled via NARs instructor tablet

• 1-HP high speed fans

• Mounted on left and right-side x 2

• 4000 CFMs output

Speakers x 4 Sound System for aircraft is a high-powered amplifier and 4 speakers to simulate aircraft noise that can be operated inside cabin and remotely. Two-way, black speakers with 300 watts peak power handling; weather-resistant poly mica cone with butyl rubber surrounds; one-inch polymer dome tweeter; heavy duty plastic cabinet and gold-plated terminals for water/corrosion resistance, 60 Hz - 20 kHz frequency range

Smoke x 1 20,000cfm, 3.3L tank capacity, 5-minute heat up, Manual fog button, Low fluid indicator and auto shut down, LED-illuminated tank

Inside Cabin Lighting x4 Lights can be turned on and off remotely. Lights can be switched between white and cyan.

Outside Beacon x1 Beacon will have the ability to be turned on and off remotely within a one-mile radius. LED optical design packs all the punch of strobe while retaining the superior performance characteristics of LEDs.

Rugged and low-profile built-in flashers with selectable flash patterns, Hi/Low intensity, built-in cruise lights and synchronization feature

Allows each unit to configure to Standard Operating Procedures

• Cabin height, width, and length to realistic sizes

• Day or night operations

• Realistic crew securing landmarks

• Equipment can be properly secured on floor

93-0074 Integrated Communications System Kit for NARS helicopter simulators. CASEVAC ICS Box with headsets ** includes ICS box, 2 communication cords (15 ft long) and 2 headsets

93-0075 HD panoramic camera set (mounted)

93-0379 Crew seats – UH60 Qty 2, 4 seats per set mounted back-to-back with custom harness system

93-0076-S Onsite New Equipment Training Provided by NARS cadre, 1 day of onsite training includes a concentrated hands-on approach to NARS equipment familiarization, assembly/set-up procedures, safe operation, post-operation maintenance, troubleshooting, and storage. Curriculum integration strategies discussed.

All items listed above include a 1-year warranty beginning the date of delivery. All warranty work for the UH-60 simulator, all component parts, software updates, communication systems, peripheral (and control) devices are provided exclusively through NARS. NARS does not utilize sub-contractors for service, training, or warranty support.

F2MTRF4113AW01

Attachment 2 3 of 9

NARS offers extended warranty programs that can be purchased at any time during the initial warranty period.

Multi-year extended warranty is available as a year-to-year option.

Technical support is available via telephone, email, text, or WhatsApp. Response time is typically same day.

There is no charge for use of technical support.

Onsite technical support is coordinated through the NARS Operation Division. Our team is in San Antonio multiple times yearly to support numerous NARS customers. Complimentary site visits are offered when our team is in the area.

Turnaround time for equipment can vary depending on the component. NARS products are engineered for easy installation and removal to minimize costly shipping charges. NARS Operations team tracks warranty and repair cases very closely to ensure prompt return to full function.

NARS currently has 1 UH-60 in stock. Additional component parts included in this proposal would require 30 days for installation from the date of the receipt of the order.

NARS products are all produced in the United States of America and are Berry Amendment, Buy America, and Fair Trade compliant.

502 CONS/JBKAE

JBSA Lackland, TX 14 May 2024

F2MTRF4113AW01

Attachment 2 4 of 9

F2MTRF4113AW01

Attachment 2 5 of 9

F2MTRF4113AW01

Attachment 2 6 of 9

F2MTRF4113AW01

Attachment 2 7 of 9

F2MTRF4113AW01

Attachment 2 8 of 9

F2MTRF4113AW01

Attachment 2 9 of 9