6-Weapons Training Facility Exterior Painting SOW.pdf

Montgomery County Specification 6588 Public Safety Weapons Training Facility Exterior Painting

Introduction The Weapons Training Facility (WTF) was built in 2007 and has been in constant use since its completion. The exterior concrete was painted in 2016, and the metal siding has not been painted since 2007. The paint has faded over the years due to sun exposure. The area around the dust collector unit has some staining from lead dust from fired lead bullets. There is some cracking and spalling of the concrete panels. The scope of work involves a comprehensive effort to improve and restore the appearance of the building’s facade.

Qualifications A. Contractor is to be lead certified.

B. Contractor must conform to proper disposal of all waste including, but not limited to, cleaning materials/waste, painting/sealing waste, or wastewater per EPA requirements.

Scope of Work A. The contractor will coordinate work schedule with the Weapons Training Facility and perform all work during business hours of the facility as instructed by weapons training facility management. ***NO EXCEPTIONS***

B. Work is anticipated to start on or around June 1, 2026 C. Prior to painting or coating all areas, power wash exterior concrete, metal siding, doors, door frames, columns, beams, rooftop HVAC units to remove contaminants. Utilize lead safe practices over the DCU exhaust area. The record drawing of the facility can be found in files as attachment.

D. Prior to painting repair all cracks, spalling and holes in exterior concrete walls (1000 lf assumed).

E. Apply two (2) coats of KEIM Soldalit mineral paint to all exterior concrete, each face of building from ground level to roof level. Color 20308 to replace the blue tone on the building and Color 9585 for all other areas of the facade.

F. Apply two (2) coats of Sherwin Williams Direct to Metal (DTM) paint to all steel siding, columns, beams, man doors and frames, garage door frame (not the garage door), and any other painted surface.

G. Apply two (2) coats of Sherwin Williams DTM to exterior of three (3) painted rooftop HVAC units.

H. All colors to be determined by the County from manufacturer’s standard range.

I. Product substitutions will be considered per the Special Project Requirements document.

J. The successful bidder shall be responsible for supplying all material and equipment for the completion of the work described. Install per manufacturer's recommendations. Deliver a complete installation that complies with all applicable Federal, State and Municipal codes, regulations and permitting procedures.

***The vendor will verify existing conditions, quantities, and dimensions regardless of County issued measurements and/or drawings that are provided***

References Please provide at least 3 professional references outlining previously performed installations similar in size to this request, using the specified products.

Provide proof of lead certification.

Montgomery County Specification 6588 Public Safety Weapons Training Facility Exterior Painting

Warranty All work shall be guaranteed by Contractor against defects in workmanship and materials for a period of one (1) year from the date of acceptance by the County. During this period, Contractor shall agree to promptly remedy, at Contractor’s expense, any defects which were caused, in the judgment of the County, by material or workmanship issues.

Pricing This is an opportunity to submit a bid that is most advantageous and cost effective for Montgomery County on behalf of the Weapons Training Facility. Please make sure to encompass costs for all required time, materials, & labor for the entire project when submitting a bid as outlined above.

PreBid Meeting Although not mandatory, it is highly recommended to attend the onsite pre-bid meeting that will be held for this project. The pre-bid meeting will be open to all Bidders, sub-contractors, vendors, suppliers, and other interested parties for this project. The location address: Montgomery County Fire Academy Training Center, 1175 Conshohocken Rd., Conshohocken PA 19428. **We will assemble in the main lobby of the Fire Academy Building, please park in the Fire Academy parking lot in front of the Fire Academy building. We will walk as a group down to the Weapons Training Facility (Firing Range).

Contract Period This contract will be in effect for 120 days from the date of full contract execution and formal notice to proceed with work.

Submission Method Responses to this RFP must be submitted through the County’s procurement submission portal, Bonfire, at https://montcopa.bonfirehub.com/portal .

Questions All questions must be submitted through the Bonfire portal and answers will be posted there for public review.

Attachments Blueprints/Drawings of the facility can be found in Bonfire, Files section. The Drawings are saved as Attachment A.

***The vendor will verify existing conditions, quantities, and dimensions regardless of County issued measurements and/or drawings that are provided***