FBO_-_3._Offeror's_Minimum_Equipment_Requirements.doc

NATIONAL SECURITY TECHNOLOGIES, LLC

SUBCONTRACTOR MINIMUM EQUIPMENT REQUIREMENTS

The following equipment list is not intended to be a complete list of items to be furnished by the SUBCONTRACTOR. The SUBCONTRACTOR is required to furnish all drilling and maintenance tools, supplies materials, and equipment not herein designated, but which are normal components for drilling operations of the scope of these specifications. Equipment includes, but is not limited to:

1.

Drill Rig:

a. With drill pipe, drill collars, and stabilizers or reamers adequate to drill up to a 14-3/4 inch angled surface hole to 40 feet and drill pipe, drill collars, and stabilizers or reamers adequate to drill an 8 inch angled borehole to approximately 500 feet with all required auxiliary tools and equipment for makeup and breakout, handling tools, and bottom hole assembly, including:

· Minimum 3-1/2 inch outside diameter (OD) drill pipe, 500 linear feet

· Minimum 4, 4-1/2 inch OD, range 2 drill collars and one short (10 foot) drill collar

· Minimum 2, near-bit roller reamers with reamer OD 1/8 inch less than bit size

· Minimum 3, string roller reamers with reamer OD 1/8 inch less than bit size

· All cross over subs necessary for make-up of bottom hole assembles (BHA) including Contractor furnished bits and hammer

b. Capability of running 9-5/8” surface casing to a maximum of 40 feet.

c. Capability of drilling minimum 8 inch diameter angle holes up to 30 degrees off vertical.

2.

Transportation:

All SUBCONTRACTOR-furnished personnel, equipment, materials to and from the job sites 3.

Electric Generators:

To supply electricity that the SUBCONTRACTOR may require

4.

Drilling Fluid Circulation System:

a.

Fluid pump and equipment necessary to drill 14-3/4 inch surface hole to maximum of 40 feet using water and/or bentonite mud b.

Rotating head and flow line with companion or other connections for top of 9-5/8 inch OD surface casing and flow line to the sump c.

Air compressors minimum 2, 900 cfm, 350 psi d.

Circulating pump for drilling surface hole and injection pump for air foam mix

5.

Safety and Emergency Equipment:

SUBCONTRACTOR shall provide all necessary safety and emergency equipment. Items such as hard hats, safety shoes, safety glasses, work gloves, first aid kits, fire protection equipment.

6.

Welding Services:

For fabrication/repair of SUBCONTRACTOR's equipment and installation of CONTRACTOR furnished surface casing, rotating head, etc.

7.

Forklift:

SUBCONTRACTOR shall provide at a minimum, a five ton forklift for moving tools and equipment on location.

8.

Fuel Tanks:

As needed for all SUBCONTRACTOR’s fuel requirements.

9.

Water Storage:

As needed for all construction water required for drilling and/or other SUBCONTRACTOR needs

10.

Plastic Liner Material:

As needed for placement under SUBCONTRACTOR’s equipment.

11.

Potable Water:

As needed for SUBCONTRACTOR and Lower-Tier SUBCONTRACTOR’s personnel.

12.

Cold Weather Equipment:

Such as heaters, wind breaks, etc., for continuous wintertime operations if and as necessary at elevations above 6,000 feet.

13.

MISCELLANEOUS SUPPLIES, PERSONNEL, AND EQUIPMENT:

Any and all miscellaneous supplies, personnel, and equipment not specifically identified above, as needed to accomplish this work.

NSTec.

Subcontractor Minimum Equipment Requirements