23-071_23230501 - Typicals.pdf
PDF 705 KB Posted
- Solicitation number
- 23-071
- Issued by
- Clinton County, Iowa
About this file
This document contains construction details for a typical handhole and locate pedestal for the Iowa Communications Network (ICN). The handhole detail shows the placement and configuration of a 24" x 36" x 30" precast concrete handhole, including the routing and coiling of fiber optic cables. The locate pedestal detail shows the installation of a tri-view locate pedestal with a steel post, terminal board, and bonding of tracer wires.
These details are provided for an ICN fiber relocation project, ICN OSP Project #23230501, along Manufacturing Dr just north of Valley West Dr to S 17th St in Clinton, Iowa. The State of Iowa, Iowa Telecommunications and Technology Commission, operating the ICN, is seeking bids from vendors to relocate the existing 4-fiber cable in this area. No specific pricing, set-asides, or funding details are provided in this document.
View the file
Other files
On GovTribe
Work with this file
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
30"
37 5/8"
26"
37 5/8"
30"
35 5/8"
24"
3"
24" X 36" X 30" HAND HOLE
HANDHOLE PLACEMENT TYPICAL
6"
37 5/8"
26"
5'
MIN.
R
I G
H
T
O
F
W
A
Y
4' TYP.
6" ±
6" ±
5'
6" ±
2-3'
12" min.
5-6"
IOWA COMMUNICATIONS NETWORK
AutoCAD SHX Text 24"x36"x30" HAND HOLE
AutoCAD SHX Text
HDPE DUCT
AutoCAD SHX Text
CABLE
AutoCAD SHX Text
SOIL GRADE
AutoCAD SHX Text
FIBER
AutoCAD SHX Text
CABLE
AutoCAD SHX Text
FIBER
AutoCAD SHX Text
CABLE
AutoCAD SHX Text
HDPE
AutoCAD SHX Text
DUCT
AutoCAD SHX Text TAPE CABLES TOGETHER MATCHING LENGTHS WHERE POSSIBLE. COIL CABLE AROUND WALLS OF HANDHOLE
AutoCAD SHX Text
TYPICAL LOCATE PEDESTAL
AutoCAD SHX Text
TYPICAL SPLICE MARKER
AutoCAD SHX Text
STEEL POST (U- OR T-POST)
AutoCAD SHX Text
3/4" CRUSHED ROCK (NO GRAVEL INSIDE HH)
AutoCAD SHX Text
DO NOT USE PEA GRAVEL OR OTHER ROUND STONE
AutoCAD SHX Text
WIRE MESH
AutoCAD SHX Text
SCALE:
AutoCAD SHX Text
SIZE:
AutoCAD SHX Text
GRIMES STATE OFFICE BUILDING
AutoCAD SHX Text
ICN
AutoCAD SHX Text C
AutoCAD SHX Text
, COPY WITH PERMISSION
AutoCAD SHX Text O:\AutoCAD Standards\TYPICALS\TYPICAL-HH PLACEMENT.dwg
AutoCAD SHX Text
AutoCAD SHX Text
DES MOINES, IOWA 50319
AutoCAD SHX Text
400 EAST 14TH STREET
AutoCAD SHX Text
THIS DRAWING IS PROVIDED FOR GENERAL
AutoCAD SHX Text
INFORMATION ONLY AND IS NOT TO BE USED
AutoCAD SHX Text
TO DETERMINE PRECISE ICN PLACEMENT.
AutoCAD SHX Text
CALL ONE CALL BEFORE EXCAVATION
AutoCAD SHX Text
(1-800-292-8989 OR 811)
AutoCAD SHX Text
AutoCAD SHX Text
AutoCAD SHX Text
AutoCAD SHX Text
AutoCAD SHX Text
AutoCAD SHX Text
AutoCAD SHX Text
AutoCAD SHX Text
AutoCAD SHX Text
REVISION
AutoCAD SHX Text
REVISION
AutoCAD SHX Text
REVISION
AutoCAD SHX Text
REVISION
AutoCAD SHX Text
REVISION
AutoCAD SHX Text
REVISION
AutoCAD SHX Text
REVISION
AutoCAD SHX Text
REVISION
AutoCAD SHX Text 8-21-15
AutoCAD SHX Text 8-19-16
AutoCAD SHX Text 8-24-16
AutoCAD SHX Text 12-11-17
AutoCAD SHX Text 7-19-18
AutoCAD SHX Text 11-4-19
AutoCAD SHX Text 6-30-21
AutoCAD SHX Text 10-11-23
AutoCAD SHX Text
CONSTRUCTION DETAIL
AutoCAD SHX Text
HANDHOLE TYPICAL - ICN STANDARD
AutoCAD SHX Text 24" x 36" x 30"
AutoCAD SHX Text
NONE
AutoCAD SHX Text 11 x 17
AutoCAD SHX Text
TYPICAL HANDHOLE
CABLE COILS NOT SHOWN
NOTES:
-LOCATE (TRACER) WIRE: #10 or #12 AWG SOLID COPPER WIRE
-GROUND WIRE: #6 OR #8 AWG SOLID BARE COPPER WIRE
-GROUND ROD: INSTALL IN BASE OF HANDHOLE, CORNER NEAREST LOCATE PEDESTAL, LEAVE ~6-IN EXPOSED ABOVE GRAVEL
-ONE LOCATE WIRE PER FIBER CABLE AT SPLICE ENCLOSURE
-LOCATE WIRE(S) TO BE BONDED INSIDE SPLICE ENCLOSURE WITH 3M SCOTCHLOK SHIELD BONDING KIT -LOCATE WIRE(S) TO BE ROUTED OUTSIDE OF SPLICE ENCLOSURE WITH FOSC CLOSURE SEALING KIT -LOCATE WIRE(S) TO BE ROUTED VIA DUCT TO LOCATE PEDESTAL AND TERMINATED AT TERMINAL BOARD -GROUND LOCATE PEDESTAL TO GROUND ROD WITH SOLID BARE COPPER WIRE AND GROUND CLAMP
-SECURE LOCATE PEDESTAL BY PLACING OVER STEEL POST
-SET PEDESTAL AT OR NEAR RIGHT-OF-WAY, IF POSSIBLE
-MINIMUM HEIGHT OF INSTALLED PEDESTAL MUST BE 5 FEET
TYPICAL INSTALLATION OF
TRI-VIEW LOCATE PEDESTAL
TRACER WIRE TERMINATION DETAIL
Termination of the locate wire at either a pedestal, puck, or in a splice case shall be made in the following fashion:
Strip off a minimum of ¾” of insulation. Using a needle nose pliers bend a wire “eyelet” on the wire end in a clockwise manner. Use a flat washer on both sides of the wire eyelet when cinching it down on the stud. Flat washers shall be of appropriate size such that the hole matches the diameter of the stud and the outside diameter of the flat washer matches reasonably close to the eyelet diameter.
IOWA COMMUNICATIONS NETWORK
AutoCAD SHX Text
HAND HOLE
AutoCAD SHX Text
HDPE DUCT
AutoCAD SHX Text
CABLE
AutoCAD SHX Text
SOIL GRADE
AutoCAD SHX Text
GROUND ROD (6" EXPOSED)
AutoCAD SHX Text
DUCT (ANY)
AutoCAD SHX Text
LOCATE WIRES
AutoCAD SHX Text
GROUND WIRE
AutoCAD SHX Text S P L I C E
AutoCAD SHX Text
STEEL POST
AutoCAD SHX Text
TERMINAL BOARD
AutoCAD SHX Text
3/4" CRUSHED ROCK
AutoCAD SHX Text
BOND LOCATE WIRES INSIDE SPLICE ENCLOSURE
AutoCAD SHX Text
GROUND WIRE BONDED TO GROUND ROD
AutoCAD SHX Text
OUTSIDE DIAMETER MUST
AutoCAD SHX Text
FIT WITHIN PEDESTAL
AutoCAD SHX Text
WITH STEEL POST
AutoCAD SHX Text
SCALE:
AutoCAD SHX Text
SIZE:
AutoCAD SHX Text
GRIMES STATE OFFICE BUILDING
AutoCAD SHX Text
ICN
AutoCAD SHX Text C
AutoCAD SHX Text
, COPY WITH PERMISSION
AutoCAD SHX Text O:\AutoCAD Standards\TYPICALS\TYP_LOCATE PEDS.dwg
AutoCAD SHX Text
AutoCAD SHX Text
DES MOINES, IOWA 50319
AutoCAD SHX Text
400 EAST 14TH STREET
AutoCAD SHX Text
THIS DRAWING IS PROVIDED FOR GENERAL
AutoCAD SHX Text
INFORMATION ONLY AND IS NOT TO BE USED
AutoCAD SHX Text
TO DETERMINE PRECISE ICN PLACEMENT.
AutoCAD SHX Text
CALL ONE CALL BEFORE EXCAVATION
AutoCAD SHX Text
(1-800-292-8989 OR 811)
AutoCAD SHX Text
AutoCAD SHX Text
AutoCAD SHX Text
AutoCAD SHX Text
AutoCAD SHX Text
AutoCAD SHX Text
AutoCAD SHX Text
AutoCAD SHX Text
AutoCAD SHX Text
FOR CONSTRUCTION
AutoCAD SHX Text
UPDATE
AutoCAD SHX Text
REVISION
AutoCAD SHX Text
REVISION
AutoCAD SHX Text
REVISION
AutoCAD SHX Text
REVISION
AutoCAD SHX Text 11-3-14
AutoCAD SHX Text 3-13-15
AutoCAD SHX Text 8-21-15
AutoCAD SHX Text 9-4-15
AutoCAD SHX Text 5-19-17
AutoCAD SHX Text 10-11-23
AutoCAD SHX Text
CONSTRUCTION DETAIL
AutoCAD SHX Text
LOCATE PEDESTAL TYPICAL
AutoCAD SHX Text
TRI-VIEW W/ISO LEVER
AutoCAD SHX Text
NONE
AutoCAD SHX Text 11 x 17
AutoCAD SHX Text
TYPICAL LOCATE PEDESTAL
| Sheets and Views |
| HH TYP STANDARD_polymer concrete |
| TYP_LOCATE PEDS-TRIVIEW.pdf |
| Sheets and Views |
| TRIVIEW |
File details come from the government source that posted it. Updated .