Main Street Well 3 & Newport Well 3 Improvements Project

The Work encompassed by the Project is more specifically defined in the Contract Documents, but in general consists of, but is not limited to the following Work: Main Street Well #3: Perform pre-removal testing and document existing pump and motor operating conditions, Remove, transport, inspect, test, and evaluate the existing pump and motor; submit condition-assessment reports, Perform downhole video inspection and submit well-condition assessment report, Convert the existing oil-lubricated line shaft system to a continuous water-lubricated configuration, where indicated and authorized, Perform brushing, bailing, chemical treatment, dual-swab airlifting, redevelopment, and related well rehabilitation only when authorized by the City based on inspection results, Rehabilitate, rewind, reinstall, or replace the existing pump and/or motor as authorized by the City, Reinstall the approved rehabilitated or replacement pump and motor and provide a complete operational pumping system, Perform startup, performance, vibration, electrical, operational testing, flushing, disinfection, and post-rehabilitation inspection where required, and Restore disturbed areas and complete closeout requirements. Newport Well #3: Perform pre-removal testing and document existing pump and motor operating conditions, Remove, transport, inspect, test, and evaluate the existing pump and motor; submit condition-assessment reports, Perform downhole video inspection and noninvasive electromagnetic casing-thickness/integrity analysis; submit well-condition assessment report, Because Newport Well No. 3 is considered fragile, perform well cleaning, redevelopment, casing repair, or other downhole rehabilitation only when specifically authorized by the City, Rehabilitate, rewind, reinstall, or replace the existing pump and/or motor as authorized by the City, Install new magnetic flow meter and MOV on the waste-discharge piping, Remove and replace the existing magnetic flow meter and MOV on the system-discharge piping, Remove existing electrical equipment as needed and furnish/install new electrical, controls, instrumentation, PLC, and SCADA work where required, Reinstall the approved rehabilitated or replacement pump and motor and provide a complete operational pumping system, Perform startup, performance, vibration, electrical, operational testing, flushing, disinfection, meter/MOV testing, and post-work inspection where required, and Restore disturbed areas and complete closeout requirements.