Inspection Facility Upgrade and Violation Vehicle Parking Improvements

Excerpt from Bricklayer and Allied Craftworkers Local Union No. 13 Collective Bargaining Agreement. Brick Masonry shall consist of, but not be limited to, the following work procedures and installation of the following materials: The laying of brick made from any material in, under or upon any structure or form of work where bricks are used, whether in the ground, or over its surface, or beneath water; in commercial and residential buildings, rolling mills, iron works, blast or smelter furnaces, lime or brick kilns; in mines or fortifications, and in all underground work, such as sewers, telegraph, electric and telephone conduits; including the installation of substitutes for brick such as all carbon materials, Karbate, Impervite or mixtures, all acid resistant materials, all terra cotta and porcelain materials, except where the foregoing materials are manufactured to substitute for tile as provided for under the category of Section 8, C, of this Code. All cutting of joints, pointing, cleaning and cutting of brick walls, fireproofing, block-arching, terra cotta cutting and setting, the laying and cutting of all tile plaster, mineral-wool, cork blocks and glass masonry, or any substitute for above materials, the laying of all pipe sewers or water mains and the filling of all joints on the same when such sewers or conduits are of any vitreous material, burnt clay or cement, or any substitute material used for the above purpose, the cutting, rubbing and grinding of all kinds of brick and the setting of all cut stone trimmings on brick buildings, and the preparation and erection of plastic, castables or any refractory materials. Cleaning, grouting, pointing, and other work necessary to achieve and complete the work under the foregoing categories; all waterproofing and black mastic waterproofing, silicone and/or substitutes sandwiched between masonry units in the interior of the wall. All terra cotta called unit tile in sizes over 6"x12" regardless of method of installation; all quarry tile over 9"x9"x1 1/4" in size; split brick or quarry tile or similar material if bedded and jointed with one operation. The bedding, jointing, and pointing of the above materials shall be the work of the craft installing same. All burnt clay extruded cellular products regardless of trade name or method of installation when used as a veneer on structures; all clay products known as terra cotta tile, unit tile, ceramic veneer and machine-made terra cotta and like materials in sizes larger than 6"x12", regardless of the method of installation. Where the preponderance of material to be installed is of the above size, and when material of lesser sizes is to be used in connection therewith, the bricklayers shall install all such materials. Brick paving comes under bricklayers' trade classification. The preparation, setup, calibration, loading operation, cleaning, and routine maintenance of any mechanical devices, automated or semiautomated systems, lasers, robotics or any other emerging technologies that are use to, including but not limited to, install, cut, set, lay, level, range, plumb, align, anchor, fasten, secure, point, joint, grout, fill, grind, polish, seal, clean, repair, replace, or store masonry units, materials and surfaces, or that otherwise assist the masonas well as the preparation and ongoing maintenance of the work area to allowed proper installation of masonry units and materials