waveguide

Qty 1450 Ft.  OFE Copper Waveguide per SLAC drawing SC-700-868-59-R3

Statement of Work

This procurement is for the fabrication of WR284 OFE copper waveguide. The work includes the procurement of starting material, fabrication, testing, and delivery in accordance with SLAC drawing SC-700-868-59-R3 and as detailed below.
1. Finished waveguide must conform to ASTM F68 metallographic class 1. Certification of conformance to ASTM F-68, metallographic class 1, and actual chemical test reports traceable to the mill heat lot number (or numbers), must accompany the shipment.
2. The mill source for this material must be, either Luvata or Hitachi.
3. Dimensions and tolerances per SLAC drawing SC-700-868-59-R3
4. Interior surfaces must be free of scratches, cold laps, galling or similar defects deeper than .001 in. as measured metallographically.
5. Minimum lengths to be 12ft.
6. A sample of the starting material must be provided to SLAC for approval prior to fabrication. SLAC will perform metallographic and chemical analysis in accordance with ASTM F68. If the starting material includes material from multiple heat lots, a sample from each heat lot must be provided.
7. A full length first article must be submitted to SLAC for approval prior to fabrication balance of order. This first article will be inspected by SLAC for conformance to dimensional, surface finish, and material quality requirements.
8. The vendor shall not subcontract the fabrication of the waveguide to another supplier.
9. The waveguide shall be packaged and shipped so as to provide protection from damage, including exposure to moisture.