Composite material cutting table and software

Added: Jun 01, 2017 4:15 pm
SOLICITATION AMENDMENT 0002-

This solicitation is hereby amended to add CLIN 0002 Data Deliverables as Not Separately Priced (NSP) and to attach CDRL A001. This offer due date is hereby extended to 14 June 2017 at 12:00PM EDT.

Added: May 19, 2017 8:23 am

SOLICITATION AMENDMENT 0001

The closing date for offer submissions is hereby extended to 07 June 2017 at 12:00PM ET.

Added: May 08, 2017 2:31 pm

N0016417Q0034 - COMPOSITE MATERIAL CUTTING TABLE AND SOFTWARE - FSC 3620 - NAICS 333249

ISSUE DATE 8 May 2017 - CLOSING DATE 19 May 2017 - 12:00 PM Eastern Time

Naval Surface Warfare Center (NSWC) Crane has a requirement for composite material cutting table to include a physical workstation and software used for controlling equipment. Workstation shall be delivered at the time of the cutting table. Software shall support Windows 10 OS. The cutting table will be utilized to cut composite pre-preg for repair of ALQ-99/ALQ-240 radomes. NSWC Crane intends to enter into a Firm Fixed Price supply contract IAW FAR 13, Simplified Acquisition Procedures. This action 100% set aside for small business.

Requirements for a Composite Material Cutting Table are as follows:
Cutting table should be capable of cutting 39 to 52 inch wide fiberglass, quartz or carbon fiber fabric impregnated with epoxy type resins.
Cutting Table Useable Width: 52" minimum to 72" maximum
Cutting Table Useable Length: 60" inches minimum" to 98" maximum
Cutting Table Overall Maximum Width and Length: 78"W X 120" L (does not include controls/computer work station.)
Cutting Surface: Cutting surface should be replaceable when worn.
Vacuum System: The cutting table shall include a vacuum system capable of holding a single ply of pre-impregnated cloth in place during cutting operations.
Vacuum System Control: Valves or blast gates shall be provided to control table vacuum.
Blades: Blades for cutting quartz and carbon fiber shall be provided. Rolling and Tangential type blades shall be provided.
Computer Control: Computer and controls shall be provided to operate the cutting table.
Computer operating system: Computer operating system shall be Windows 10.
Software: Software shall be provided for operator interface with the machine controller. Software shall include toolpath generation and pattern nesting functions and shall be Windows 10 compatible.
Power: The cutting table (including vacuum system motor, computer and controller) shall operate on available 120/208V 30 Amp 3 phase power and 115 volt 15 amp single phase power.

Inspection and Acceptance is to be at destination with delivery F.O.B. Destination: Crane IN 47522-5001.

Contractors must be properly registered in the System for Award Management (SAM). Offerors may obtain information on SAM registration and annual confirmation requirements by calling 1-866-606-8220 or via the internet at https://www.sam.gov.

The anticipated award date is 30 JUNE 2017.

All changes to the requirement that occur prior to the closing date will be posted to FedBizOpps. It is the responsibility of interested vendors to monitor FedBizOpps for amendments that may be issued to this solicitation. For changes made after the closing date, only those Offerors that provide a quote will be provided any changes/amendments and considered for future discussions and/or award.

No hard copies of the solicitation will be mailed. Quotes must be submitted in the format specified in the solicitation. It is the responsibility of the Offeror to submit offers to the POC at NSWC Crane.

The POC is Jennifer Shepherd, Code 0242, Tel: 812-854-3860, or email jennifer.shepherd@navy.mil. Ensure all quotes are received by 19 MAY 2017 and before 12 PM. EST.