Award of N44255-08-C-6001, P-978 Missile Assembly Building 3 at Naval Base Kitsap Bangor, Silverdale, WA

The Naval Facilities Engineering Command, Northwest is in the process of awarding a Firm Fixed-Price Contract to provide all labor, materials, and equipment to build a Missile Assembly and Test Building (MAB) 3 located at Naval Base Kitsap at Silverdale, WA. The MAB includes a requirement for the installation of 17,532 SF of conductive flooring, identified by name brand Stonlux AT; a product of Stonhard, Inc. The conductive floor shall meet all the requirements specified in NAVSEA OP-5 paragraph 5-5.3.1. The flooring must be conductive and may be a monolithic or layered system (with a topping). If conductive topping is used, it shall be seamless and not less than 70 mils thick. Testing shall demonstrate: Compressive Strength: ASTM C-579, a minimum of 6000 PSI and minimum 3 samples; Hardness: ASTM D-2240, a minimum 80 D scale and minimum of one test every 200 square feet; Abrasion Test for Hardened Patches: Spin drive tractor wheel under 35 PSI operating pressure for 30 seconds at one spot. Minimum of 5 tests required. Successful test shall not leave any mark or abrasion under the bearing area of the wheel; Weight Loss in Abrasion: (for all areas) less 80 mg (CS-17 wheel 1 kg load 1000 cycles). Minimum three samples; Adhesion: minimum 250 PSI and minimum of 3 tests; Reflectivity: Read light level with meter facing floor and then facing up ~ at 30 inches above floor, 50% minimum reflectivity. Interested manufacturers must demonstrate the product has been successfully installed in a minimum of two facilities of similar floor area, and which have been successfully in operation for a minimum of five years, with similar wheel loads, to be considered. Provide all special installation requirements, along with surface moisture requirements for application, and warranties for the Conductive Flooring products. This sole source requirement is pursuant to FAR 6.302-1. This Notice of Intent is not a request for Expressions of Interest (EOIs), competitive proposals or proposals. No solicitation document exists and no telephone inquiries will be accepted. No contract award will be made on the basis of EOIs, proposals or quotations received in response to this notice. Interested persons may identify their interest and capability to respond to the requirement, and must furnish detailed data concerning their capabilities to provide the product sought including pricing data and technical data sufficient to determine that a comparable source to the government is available. The Government will be the sole determiner regarding an offerors ability to meet the requirement. A determination by the government not to compete this requirement based upon responses to this notice is solely within the discretion of the government. Information received will be considered solely for the purpose of determining whether a comparable product is available and whether the requirement should be competed. All responses or questions must be in writing via email (no telephone inquires will be accepted), send all responses/or questions to Carla Echols, at carloso.echols@navy.mil. All responsible sources will be considered. The government will consider all submissions received prior to 30 days after date of publication of this synopsis.