PR_10811506_Truck_SOW.pdf

DEPARTMENT OF THE ARMY AND AIR FORCE

JOINT FORCES HEADQUARTERS - NEW YORK

330 OLD NISKAYUNA ROAD

LATHAM NY 12110-3514

J3-DO-24CST 17 December 2015

MEMORANDUM FOR RECORD

SUBJECT: Statement of Works for Operations F450 Modification

1. FORD F450

a. CONSOLE: Install vehicle specific RAM console or equivalent in the color black.

Including vents, two 12 volt power outlets, XTVA radio slot, dual USB Chargers, 2 radio speakers, battery boost, high idle, and other equipment. A detailed computer generated drawing will be submitted for approval.

b. EMERGENCY VEHICLE ELECTRICAL SYSTEM: Leave the factory alternator in place to retain the full factory warranty. Battery shall remain OEM unless specified below.

Emergency lighting, equipment and accessories are wired to a master power circuit breaker with manual disconnect and a solenoid operating with the ignition switch. These components are mounted to an aluminum panel under the hood in a location that does not interfere with any factory equipment or service. The panel shall include an engraved placard with identification of the parts, manufacturer and service contact information.

j. FRONT BUMPER: Install a Fab Fours FS11-A2670 BAE front bumper or equivalent. Bumper must have a 2.5” receiver tube. Two Tie down D-Rings capable of 10,000lbs.

Winch control plug slot. Bumper must be black powder coated. Dimensions are required to match attached bumper diagram and photo.

JUSTIFICATION: Bumper will provide a front hitch mounting location for supplied winch.

Vehicle is the primary Search and Extraction Vehicle. The updated bumper will provide multiple anchor locations for high and low angle rope extractions/rescue. Bumper is required to match existing unit bumpers for uniformity and air load compatibility.

k. CUSTOMER SUPPLIED WINCH. Power cables are required for install on the front and rear hitches. Utilize a locking hitch pin to secure winch to bumper.

l. CUSTOMER SUPPLIED XTVA: Install Motorola XT Vehicle Adapter (XTVA) inside center console. Install customer supplied amplifier.

m. MOBILE RADIO: Install a Motorola APX7500 09 Radio or equivalent to center console. Radio operation, maintenance, programming, trunking compatibility, and support must mirror and align with current unit Motorola infrastructure and training. Radio must be able to

J3-DO-24CST 17 December 2015 SUBJECT: Statement of Works for Operations F450 modification control vehicle emergency lights, vehicle PA, and vehicle horn.

JUSTIFICATION: Vehicle was issued to unit w/o any communication equipment. Radios will provide the ability to communicate with our First Responder partners who operate on multiple bands during Response and Standby missions. Radio will is also control unit emergency lighting.

Installation is in compliance of NGB Guidance for CRE NTV 2015-10-19-091350.

n. ANTENNAS: Install a UHF, VHF, 800 MHz, Triband, and a satellite antenna (AT1621-142W) or equivalent to the top of the truck body. Install STI-CO Tri-Band Coupler or equivalent (UHF, VHF, and 800MHZ) from the XTVA to 3-40amps(UHF,VHF, and 800MHZ).

JUSTIFICATION: Vehicle was issued to unit w/o any communication equipment. Radios will provide the ability to communicate with our First Responder partners who operate on multiple bands during Response and Standby missions. Radio Amps will provide the unit to communicate at a greater distance. Installation is in compliance of NGB Guidance for CRE NTV 2015-10-19-091350.

o. SATELLITE PHONE HANDS FREE: Install customer supplied satellite phone hands free docking station onto center console.

JUSTIFICATION: Vehicle was issued to unit w/o any communication equipment. Radios will provide the ability to communicate with our First Responder partners who operate on multiple bands during Response and Standby missions. Installation is in compliance of NGB Guidance for

CRE NTV 2015-10-19-091350.

2. EMERGENCY LIGHTING

a. GRILL LIGHTING: Four Whelen M7 LED lights or equivalent mounted to the cross bar of the push bumper. Alternating Red and Blue. Size and location will be equal to as shown in Front Bumper photo.

b. FRONT LIGHTBAR: Whelen 79”4500 LED flush mount light bar or equivalent on the body. Alternating Red and Blue.

c. HEADLIGHT LED FLASHERS: White LED inserts or equivalent in the front headlights, two per light.

d. SIDE WARNING HIGH: Two Whelen M9# Warning Lights or equivalent Mounted high on each side of the body.

e. SIDE SCENE HIGH: Two Whelen M9# Scene Lights or equivalent mounted high on each side of the body.

f. SIDE WARNING LOW: Four Whelen Vertex™ Super-LED® Lights or equivalent mounted in the side of the running boards on each side.

g. TRAFFIC DIRECTIONAL: Whelen 8 LED Traffic Directional mounted above the rear doors on the roof of the body, with controller in the console.

h. REAR WARNING LIGHTS: Two Whelen M9 Warning Lights or equivalent mounted high, under scene lights, on each side of the rear of the body.

i. REAR SCENE LIGHTS: Two Whelen M9 Scene Lights or equivalent Mounted High on the each side of the rear of the body.

j. REAR WARNING LIGHTS LOW: Two Whelen Micro Lights or equivalent

Mounted low on the rear body.

k. HORN RING: Activate Horn Ring

l. SIREN: Install a Whelen 100 Watt Speaker and Howler™ Low Frequency Tone

Siren or equivalent mounted behind the grill.

m. TRAILER EMERGENCY LIGHT SELECTOR: Utilize emergency light control to activate trailer emergency lights utilizing existing trailer 5-Pin connection.

JUSTIFICATION: Unit is authorized emergency warning devices for vehicles and recommended configuration aligns with our local law enforcement partners. Installation is in compliance of NGB Guidance for CRE NTV 2015-10-19-091350

3. 120 VOLT AC POWER

a. INVERTER: One 1000 watt Pure Sine Wave or equivalent inverter installed in the rear of the vehicle.

b. OUTLETS: Two 15amp GFI Duplex outlets mounted inside of the truck body. One near the rear doors and the other to the front of the truck. One Duplex Mounted on the side of the console. Install one 2 Port USB Wall Plate in the truck box with two 3.0 USB cables run to the truck Ram Console.

JUSTIFICATION: Inverter will allow equipment to charge during staging areas as well as operate radiological detection equipment during passive monitoring missions. Installation is in compliance of NGB Guidance for CRE NTV 2015-10-19-091350.

4. BODY COMPARTNETS LIGHTING AND LOCKS

a. COMPARTMENT LIGHTING: LED Compartment lighting Installed inside the side body compartments. Lighting to operate when the compartment is open.

b. COMPARTMENT LOCKS: Electric compartment door locks installed on the side compartments and rear door with switch installed on the front console.

c. WHEEL CHALKS: Two removable metal wheel chalks mounted on the rear driver side of the body. Located and constructed equal to attached photo.

JUSTIFICATION: Unit operates during limited visibility and vehicle currently has no interior lighting in truck box. Lighting will assist in maintenance, loading and unloading, and accountability operations during limited visibility due to night operations.

5. WARRANTY

a. Chassis warranty: The chassis is warranted by the manufacturer of the chassis.

Extended warranties are available for an additional fee.

b. Conversion warranty: Wiring and fabrication workmanship are covered for no less than 100,000 miles on the vehicle beginning on the date the vehicle is delivered to the original purchaser.

6. Point of Contact for this memorandum is MAJ Michael Keyes at 518-337-7464 or michael.s.keyes.mil@mail.mil.

AUTHORITY LINE:

3 Encls Benjamin W. Genthner

1. Front Bumper Diagram MAJ, SC, NYARNG

2. Front Bumper Photo Commanding

3. Wheel Chalk Photo mailto:michael.s.keyes.mil@mail.mil