16-P-00XX__Air_Compressors _Controllers _and_Switches_and_for_the_Tug_ _DERRICKBOAT_2016_03_04_SOW_-_Cheraw_and_McCauley_Air_Compressors.doc

SCOPE OF WORK

FOR

AIR COMPRESSORS, CONTROLLERS AND SWITCHES FOR TUG CHERAW AND DERRCKBOAT MCCAULEY

REV. 04 MAR 2016

1. SCOPE OF WORK

a. Location of Delivery: The USACE Cleveland Reservation is located at 1035 East 9th Street, Cleveland, OH 44114.

b. Requirements Provide separate prices for each line item, FOB the delivery location. Provide complete product data for each item with the bid, fully documenting and certifying compliance with all of the specifications given below. Required bid items are as follows:

i. Provide three (3) air compressors. The new air compressors shall be two-stage, base mounted, air cooled, each capable of providing a minimum of 50 SCFM at 150 psi operating pressure. The two (2) air compressors must be approximately the same size as the current compressors. The dimensions of (1) one of these compressors is approximately 4 ½’ x 2 ½’ x 3’. The existing separate dedicated electrical circuits serving the compressors are each 208VAC, 20 amp, 3 phase, 60 hZ.

ii. Provide three (3) motor controllers / starters. The new motor controllers /starters for the compressors shall each be equipped with a three way switch. Switch positions shall include OFF, AUTO (compressor operation controlled by the pressure switches to keep the air pressure within operating range), and ON (compressors will run continuously, increasing the system pressure until the air system pressure relief valves actuate). The new motor controllers shall be rated to match the characteristics of the new compressors.

iii. Provide three (3) pressure switches. The two new pressure switches for the air compressors shall be set to turn the compressors on at a minimum pressure of 125 psi, and off at a maximum pressure of 140 psi. The pressure switches shall be rated to match the characteristics of the new compressors.

iv. Delivery of all items to the location specified above (if not included in the other bid item prices).

c. Supplier’s Qualifications. With the bid, the supplier shall provide the following information regarding the qualifications of the manufacturer and installer:

i. Statement certifying that the supplier has a minimum of 5 years experience in the supply of the items required in this solicitation.

d. Performance Required. The items will meet or exceed all minimum requirements issued in this contract.

e. Warranties. A single source supplier’s warranty shall be issued by the supplier for all products as follows: 1 year parts and labor.

f. Completion of Work. Completion of work shall include submittal and approval of product data. Acceptance of the equipment and attachments. Delivery of all items shall be made with 14 calendar days of the award of contract.

g. Final Inspection. Refer to Federal Acquisition Regulation clause 52.246-2 -- Inspection of Supplies -- Fixed-Price

2. QUALITY OF MATERIALS

a. All materials, supplies, or articles required for work shall be standard products of reputable manufacturers and entirely suitable for the intended purposes.

b. All materials shall be new and unused and will be subject to the approval of the Contracting Officer.

3. RISKS AND LIABILITIES

a. Refer to Federal Acquisition Regulation clause 52.247-21 -- Contractor Liability for Personal Injury and/or Property Damage.

4. DELIVERY HOURS

a. Delivery shall be made within the hours of 0700 to 1530 on Monday through Friday.

5. BID FORM

Total Bid