Crestron_JFHQ_Conf_RMs_Refresh.pptx

Current Door Entrance Old Crestron Location Junction box hole Drilled Here

TV

TV

VTC

New Crestron Location HDMI Cables x4 (approx. 50 ft.)

CAT 6 STP

(Underneath Floor approx. 50 ft.)

Conference Room Layout

TV

TV

Crestron Equipment Refresh (2nd Floor Conference Room)

1. Relocate existing cabinet as depicted on slide one.

2. Remove old Crestron equipment from the existing cabinet and turn in to AL ARNG. Install the new Crestron equipment into the cabinet.

3. Remove all old cables that will no longer be used and turn over to AL ARNG.

4. Drill one hole in the metal/concrete floor under the new cabinet location and install a plastic bushing around hole. This hole should be as small as possible to accommodate the cables.

5. Install two 50' shielded cat 6 cables, terminated with shielded RJ 45 connectors on each end using wiring standard 885B. Install a junction box in the center of the room near the roll around monitors to the hole in the floor under the new cabinet location. Extend power and install outlets. Leave a pull string in place for future requirements. See picture on slide 4 for a similar application. Install two AL ARNG provided TVs on roll around mounts near the junction box.

6. Install two 50' 4K High Quality HDMI cables. One each from behind the two wall mounted TVs to cabinet, using 1-Gang White Decorator Cable Access Brush Wall Plate Inserts. Both HDMI cables will utilize a single 1-Gang White Decorator Cable Access Brush Wall Plate Insert at the cabinet.

7. Install HDMI Cables from VTC equipment to cabinet, using a 1-Gang White Decorator Cable Access Brush Wall Plate Insert at the VTC equipment, and utilize previously installed access wall plate from step 6 at cabinet.

8. Remove two existing 50” TVs from the wall and mount two new 70” TVs, along with mounts, provided by AL ARNG. Existing TVs will be turned over to AL ARNG.

9. Install a power strip in the cable junction box in the floor to provide power to the roll around TVs.

10. Program new Crestron equipment and ensure that it functions properly with all peripheral devices.

Crestron Equipment Refresh (3rdFloor Conference Room)

1. Replace Loaner equipment with newly purchased equipment.

Re-connect all currently existing cables.

Program new Crestron equipment and ensure that it functions properly with all peripheral devices.

Note: This room already has a complete installation solution. No additional work will be required in this room.

Install Junction box similar to the one pictured below in the center of Conference room #2.

Notes All programming code will be provided to the AL ARNG.

Demonstrate to AL ARNG personnel that all equipment functions properly and that all peripheral devices display as Any damages due to installation will be repaired at expense of the contractor.

Rooms must be cleaned and in presentation order at the end of the installation and testing period.

image1.png image2.jpeg image3.jpeg