XGFG162024_Resinous_Floor_Spec.pdf

RESINOUS FLOORING 096723 - 1

RESINOUS FLOORING

PART 1 - GENERAL

1.1 SUBMITTALS

A. Product Data: Include manufacturer's technical data, application instructions, and recommendations for each resinous flooring component required.

B. Installer Certificates: Signed by manufacturer certifying that installers comply with specified requirements.

1.2 QUALITY ASSURANCE

A. Installer Qualifications: Manufacturer's authorized representative who is trained and approved for installation of flooring systems required for this Project.

1. Engage an installer who is certified in writing by resinous flooring manufacturer as qualified to apply resinous flooring systems indicated.

1.3 DELIVERY, STORAGE, AND HANDLING

A. Deliver materials in original packages and containers, with seals unbroken, bearing manufacturer's labels indicating brand name and directions for storage and mixing with other components.

1.4 PROJECT CONDITIONS

A. Environmental Limitations: Comply with resinous flooring manufacturer's written instructions for substrate temperature, ambient temperature, moisture, ventilation, and other conditions affecting resinous flooring application.

B. Lighting: Provide permanent lighting or, if permanent lighting is not in place, simulate permanent lighting conditions during resinous flooring application.

C. Close spaces to traffic during resinous flooring application and for not less than 24 hours after application unless manufacturer recommends a longer period.

PART 2 - PRODUCTS

2.1 MANUFACTURERS

A. Manufacturers and Product:

RESINOUS FLOORING 096723 - 2

1. Tennant Company, Floor Coatings Div., 701 N. Lilac Drive, Minneapolis, MN 55440

a. Primer: Eco-CRU Primer

b. Topcoat: Wearguard CRU

2. Approved Equal.

2.2 INDUSTRIAL RESINOUS FLOORING

A. Resinous Flooring: The combination of the primer coat(s) and topcoat(s) shall provided an abrasion-, impact- and chemical-resistant, non-slip monolithic floor surfaced designed to produce a seamless floor.

B. System Characteristics:

1. Color: Field color shall be white.

2. Wearing Surface: Slip resistant - smooth surface or orange-peel texture. (slip resistant grit is not permitted)

C. Primer and Intermediate Coats: Epoxy

1. Application Method: Per manufacturer’s recommendation.

D. Topcoat: Urethane

1. Type: Solid Color - White

2. Finish: Gloss.

2.3 ACCESSORIES

A. Joint Filler: Polyurea joint fill system as recommend by manufacturer.

B. Epoxy Mortar: As recommended by manufacturer.

PART 3 - EXECUTION

3.1 PREPARATION

A. General: Prepare and clean substrates according to resinous flooring manufacturer's written instructions for substrate indicated. Provide clean, dry substrate for resinous flooring application.

B. Resinous Materials: Mix components and prepare materials according to resinous flooring manufacturer's written instructions.

RESINOUS FLOORING 096723 - 3

C. Use patching and fill material to fill holes and depressions in substrates according to manufacturer's written instructions.

D. Treat control joints and other nonmoving substrate cracks to prevent cracks from reflecting through resinous flooring according to manufacturer's written instructions.

3.2 APPLICATION

A. General: Apply components of resinous flooring system according to manufacturer's written instructions to produce a uniform, monolithic wearing surface of thickness indicated.

B. Apply primer and intermediate coats in accordance with Manufacturer’s instructions to achieve a minimum Dry Film Thickness of 25 mils.

1. Primer coat: 5 mil minimum

2. Intermediate (high-build) coat: 20 mil minimum

C. Apply 2 coats of topcoats as follows:

1. The combination of the two coats shall have a combined thickness of 5.4 mils.

END OF SECTION 096723

2. Approved Equal.