A709 HPS 70WF3 Sample Layout.pdf

The image is a technical drawing/sample layout diagram for steel plate cutting specifications, showing three vertically stacked sections with identical pink/magenta outlines of steel plate configurations. Each section contains spoon-shaped or curved-end rectangular shapes with small square markings. The diagram includes precise dimensional measurements in red, with overall vertical height around 20 units and horizontal width around 8-9 units. Numbered markers (2, 4, 5) are positioned within the sections, and the layout appears to be a precise engineering schematic for steel plate fabrication and cutting specifications.

This technical drawing corresponds directly to the federal contract opportunity for the U.S. Army Corps of Engineers, which requires three ASTM A709 HPS 70WF steel plates (4" thick x 8' x 20') to be cut into three equal pieces (80" x 96") for miter gate anchorage components at Locks 5, 6, and 9 on the upper Mississippi River. The steel material must meet strict specifications including compliance with Buy American Act, specific chemical and tensile testing requirements, clean cut edges, proper marking, and delivery to the Corps of Engineers Service Base in Pleasant Valley, IA by October 20, 2025, with the solicitation number W912ES25QA039.