Specifications..pdf
PDF 382 KB Posted
- Attached to
- P24-1460 Jackson Traps
- Solicitation number
- P24-1460
- Issued by
- Orange County, California
About this file
The document is a set of technical specifications for a Jackson Trap Body, intended for use with Medfly, Oriental FF, or Melon FF insect traps. The specifications detail precise manufacturing requirements for a trap body made of white, bleached sulphate solid paperboard that is 0.024 inches thick and polyplastic-coated on both sides. The trap is designed to be 5 inches long by 3 3/4 inches on each side, with specific sealing requirements to ensure waterproofing and heat resistance up to 120 degrees Fahrenheit.
The trap body must be constructed using either a flame sealing or adhesion process, with a 5/8 inch wide flap sealed at the top. The document specifies that the trap should have a single scored crease at the center bottom to allow flat folding for packaging and storage. The trap's outer side panels must be labeled according to an attached sample, with the flame-sealed flap located on the panel imprinted with "INSECT TRAP". While no specific procurement details are provided, the specifications appear to be for a federal state government insect monitoring and control program, with a focus on precise technical requirements for trap construction.
View the file
Other files
| File | Type | Posted |
|---|---|---|
| Informal_Competitive_RFQ.pdf |
On GovTribe
Work with this file
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
JACKSON TRAP BODY SPECIFICATIONS
The normal service employment of these traps will subject them to rainfall, direct rays of sunlight and high temperatures; therefore, it is necessary that the adhesion or other method of sealing (i.e., flame sealing) used for fabrication of the trap be waterproof and heat resistant.
Item shall be made of white, bleached sulphate, solid paperboard .024 inch thick (.6096 mm) and polyplastic-coated on both sides.
TRAP BODY
• The trap body shall be 5 inches (12.7cm) long by 3 3/4 inches (9.525cm) on each of three sides. The contact surfaces of the fold over flap shall be finished via one of two methods: flame sealing or adhesion process.
1. Flame Sealing: One side shall be flame sealed to a 5/8 inch (1.59cm) wide flap that is lapped over the outside of the adjoining side, and located within 5/8 (1.59cm) of an inch above imprinted insect trap logo. Flame sealing is a reactivation process used to create a positive seal when fusing a double poly surface. The flame sealed seam shall be positioned at the top of the trap. The fusion process used to fabricate the trap must be waterproof, able to withstand temperatures of 120 degrees F (49 degrees C) and constant exposure to direct sunlight.
2. Adhesion Process: Removal of the poly coated surface prior to trap adhesion process (gluing) meeting the same specifications as above (1.).
• In addition to the folded creases for forming the triangle shaped trap, there shall be a single scored crease within the triangle surface, located at the center bottom of the trap body, on the non-printed side (inner surface) of the trap body, so the trap can be folded flat for packaging and storage.
• An insert shall fit tight enough in the trap to prevent sliding out when exposed to wind and weather.
• Inserts for the traps are not needed, only the traps themselves are needed.
• The two outer side panels shall have the labels imprinted as per the attached sample.
• The flame sealed flap shall be on the trap side imprinted with "INSECT TRAP" (panel 2 in the attached diagram).
Julian Gutierrez Pencil
File details come from the government source that posted it. Updated .