SP7000-16-Q-0041_Statement_of_Work_for_5043_ _Drawing.pdf

Cylinder Recover Information for 5043

Cylinder shall be provided for recovery

The shaft which supports the roller in the press shall extend through the length of the cylinder, and four reinforcing webs equally spaced through the length of the cylinder shall be welded in place to keep shaft centered in the cylinder and insure rigidity in construction. After the rubber impression plates have been attached to the steel cylinder, the major diameter or printing surface shall be finished concentric with supporting bearings.

The design covering shall be cut, 60-65 durometer or molded, 55-60 durometer, abrasive resistant, natural rubber plates. The plate must have an etching depth of approximately .100 and a thickness of approximately .150. These will be outside diameter of type cylinder.

Approx. Cylinder Specs:

Cylinder Diameter - 23.09” Cylinder Length - 74”

The target will be printed 1-up (1-around – 1-across) with a cutoff length of 72.25 inches. The printing surface (72-inches) shall be centered on the cylinder so that 1 target 73 inches wide will be printed.

Drawing for target “Rifle B Modified 5043 drawing #9349437” is attached.

Acceptance of the cylinder will be based on acceptance of a printed target within tolerances shown on drawing #9349437.

A “repeat” line shall be added for cutoff registration. The “repeat” line shall be .375 tall and .500 long located on the operator side (non-gear side of the cylinder).

Shipping box will be provided and may need strengthening prior to shipping back to DLA Document Services. DLA will cover shipping costs to and from the vendor.