SOWLARGEMETALLOGRAPHICSAW 2.pdf

PERFORMANCE WORK STATEMENT

1. Mechanical Test Lab

12 June 2024

Requiring Activity: DLA Product Test Center Division, Mechanical Lab, located at Cols, Ohio.

Contracting Activity: DLA Contracting Services located at Cols, Ohio.

2. Introduction

This is a description of the DLA Mechanical Product Test Center (MPTC) requirements for the procurement of a Large Metallographic Cut-off Saw. It is the intent here to clearly define all required performance characteristics. In generating this statement, our objective is to end up with a large metallographic cut-off saw which replaces obsolete / non-operating equipment. This acquisition will improve sectioning time and allow for a greater diversity of parts received from the Product Verification Test Coordinators. Our general objective is to minimize any impact to the MPTC operations and our customers as a result of this procurement, especially with regards to test cycle time. This equipment will decrease time required to section parts and remove any discrepancies with current sectioning equipment. This machine will replace non-functioning Leco sectioning equipment with newer and more technically advanced equipment.

3. Background

This equipment would increase MPTC’s sectioning efficiency and accuracy, help improve testing turnaround time, and replace one non-operational Leco cut-off saw. Most importantly procurement of this equipment will increase our current metallographic testing capacity. Not procuring this piece of equipment would leave the MPTC with only one fully functioning manual cut-off saw.

4. Scope

Install one Struers Large Metallographic Cut-off Saw.

5. Applicable Directives

None

6. Performance Requirements

The Contractor will install and provide training on the new Large Metallographic Cut-off Saw in the Mechanical test lab.

7. Deliverables

One Struers Discotom-100 Large Metallographic Cut-off Saw.

9. Place of Performance

DSCC Columbus Building 9 Section 1 3990 East Broad Street Whitehall, OH 43213

Shipped receivable to Bldg 17

Marked for Bldg 9 section 1

Attn: William Myers 614-692-7074

Work to be performed will take place at: Building 9, Section 1

10. Travel (if applicable)

Contractor is responsible for travel to Place of Performance listed in section 9.

11. Invoicing

Payment of invoices will be accomplished by payment through the Defense Finance and Accounting Service. Invoices will be submitted to the Wide Area Workflow system in accordance with DFARS 252.232-7003 Electronic Submission of Payment Requests and Receiving Reports and DFARS 252.232- 7006 Wide Area Workflow Payment Instructions within 10 workdays after the conclusion of each training session.

12. WAWF Acceptance DODAAC#

TM Lab is SL0702.

13. Point of Contacts

The Government Contract Officer:

TBD

The Government Contract Officer Representative (COR):

Kyle Palmer Kyle.Palmer@dla.mil 614-692-8860

DLA Land and Maritime Product Test Center, T Office 3990 E. Broad St., Columbus, OH Bldg. 9, Section 1 Attn: William Myers 614-692-7074

The Government Technical Representative/Project Manager:

Name: William Myers Phone Number: (614) 692-7074 Email Address:

William.1.myers@dla.mil mailto:Kyle.Palmer@dla.mil