SOW v2 JLG 1200 BOOM LIFT.pdf

STATEMENT OF WORK

Joint Base Charleston 628 CES needs the following the repair and replacement of cylinder seal kits to include the platform level, holding valve, hydraulic hose replacement, replace all of the decals, O‐Rings, switches and knobs. Conduct a thorough inspection to identify potential issues, diagnose and correct engine misfire and refill hydraulic fluid. This requirement will include pickup and delivery of the JLG 1200 Boom lift from Joint

Base Charleston, SC.

1. Transport JLG 1200 from Joint Base Charleston to your shop. Purchase and install all needed parts.

Reassemble with new cylinders seal kits, hydraulic hose assemblies, and decals, knob and switches, perform a thorough inspection, identify and inspect cause of engine misfire. Transport JLG 1200 back to the Joint Base Charleston. Upon return to JBC, ensure Boom lift meets factory and OSHA standards to ensure the safety of operators using the JLG 1200 boom lift.

2. Contractor shall inspect, evaluate, and provide justification if additional repairs are required to meet operational manufacturer standards. Once it has been determined at the contractor's repair shop that additional repairs and/or replacements are needed, the contractor must provide a repair quote to the contracting office for approval. Approval to proceed will occur by means of a contract modification in which the repair can then be completed prior to returning the boom lift for final drop off at JB Charleston. Monetary funds will need to be requested by the contracting office for the repairs and approval to proceed will occur by means of a contract modification. Contractor will only invoice for actual parts and services provided.

3. Before performing any action in a non‐contractual nature or is considered out‐of‐scope, the Contractor shall contact the Contract Specialist and the Contracting Officer identifying the reason(s) for change. All changes shall have prior authorization from the Contracting Officer in the form of a written modification. Below is a list of the estimated parts that need to be replaced.

Seal Kit platform (Part # 2902087 or equal) 1 Each

Seal Kit holding valve (Part # 2900792S or equal) 1 Each

Counterbalance valve (Part # 4641248S or equal) 1 Each

Hydraulic hoses (Part # 2753717 or equal) 2 Each

Decal platform (Part # 1001108708 or equal) 1 Each (kit)

Decal console (Part # 1001109181 or equal) 1 Each (kit)

O‐rings (Part # 3790012 or equal) 11 Each

Toggle Switch (Part # 4360331S or equal) 2 Each

Toggle Switch (Part # 4360328S or equal) 7 Each

Toggle Switch (Part # 4360336S or equal) 1 Each

Toggle Switch (Part # 4360330S or equal) 1 Each

Electrical potentiometer (Part # 4360407 or equal) Knob (Part # 2560136 or equal)

Spirax S4 TMX Tractor hydraulic fluid Gallon

1 Each 1 Each 15 Each

Perform thorough inspection 1 Each

Diagnose and correct engine misfire 1 Each