II.D.2. Attachment 2 Qand A 18OCT2023.pdf
PDF 556 KB Posted
- Attached to
- Dynamometer Federal contract opportunity
- Solicitation number
- N6660424Q0039
About this file
This document contains questions and answers regarding a solicitation for a dynamometer. The solicitation seeks to replace an existing dynamometer with a new motor and control system. The new dynamometer must have a motor base that reaches a centerline height of 27 inches. The existing dynamometer input shaft and mounting flange can be reused but are not required. The solicitation is available through the Department of the Navy Naval Sea Systems Command under number N6660424Q0039. Site visits are available upon request for vendors to better understand the existing installation that is being replaced.
View the file
Other files for this federal contract opportunity
| File | Type | Posted |
|---|---|---|
| Attachment 1 Requirements Document.pdf | ||
| N6660424Q0039.pdf |
On GovTribe
Work with this file on GovTribe
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
1. Is this Motor connected to an exis ng Motor Drive?
RFQ is for a Dynamometer to create, control and measure load of a test article.
2. Will the exis ng Motor Drive be used or needs to be replaced with the new motor?
N/A
3. If re-used, please advised the exis ng Motor Drive will work with and easily adapt to the new motor.
N/A
4. Will new controls and so ware be required? Please provide more detail.
Vendor will provide necessary Dynamometer control system
5. What is the current power availability to the exis ng dyno?
110V 20A
6. Will the moun ng flange of the exis ng dyno be re-used to a ach the new motor to the tes ng ar cle?
Exis ng Dynamometer input sha to test item flange is available to use but is not required
7. If yes, please advise the sha sizing and requirement to connect the exis ng flange onto the new motor sha .
1. Dynamometer input sha will mate with exis ng flange depicted below (item #3)
Figure 1 - Dyno interface with Shafting (Dyno on left)
Figure 2 - Side View Item #3
Figure 3 - Front View Item #3
8. Will the new motor be a ached to the exis ng motor base or does a new base need to be provided?
Dynamometer base must be provided to reach input sha centerline height of 27”
9. Does the exis ng motor base slide in/out to connect to the tes ng ar cle?
No
10. What is the centerline height of the dynamometer sha ?
27”
11. Is there access available to move the motor into the tes ng area with a forkli ?
No forkli access
12. Will you be se ng up a sight visit or can we visit the site to see the exis ng installa on and be er understand what is to be replaced.
Site visit available on request. Government will not pay expenses.
File details come from the government source that posted it. Updated .