Purchase_Spec_for_Ultrasonic_Wash_Tank.pdf

Purchase Description and

Specifications for

Ultrasonic Wash Tank

309 MXSG

March 26, 2015

1. DESCRIPTION OF REQUIREMENTS:

Ultrasonic, heated wash tank that is used to dissolve unwanted support material that remains after an item is 3D printed.

2. ACCESSORIES AND SPECIFICATIONS:

The Ultrasonic wash tank must meet the following specifications and processes:

2.1 Withstand a heated, highly alkaline sodium hydroxide solution

2.2 Provide temperature of 0 to 180 degrees Fahrenheit

2.3 Internal tank size between 36x24x36 inches and 40x30x40 inches

2.4 Automatic shut-off digital timer

2.5 Drain on the bottom or pumping as a method of draining

2.6 Operation and instruction manual

3. GENERAL REQUIREMENTS:

General requirements delivered by supplier shall include:

1.1. Maintenance and repair support for requests with repair start-up within three business days

1.2. Technical support for requests with response time within 48 hours

1.3. 12-Month parts and labor warranty

4. PRODUCT SPECIFICATIONS:

BASE SYSTEM

CONFIGURATION

Internal Tank Size Between 36x24x36 inches and 40x30x40 inches

Tank

Composition Able to withstand heated, highly alkaline solution.

Tank Drain Drain should be at the bottom, or unit should contain a pump for draining

Timer Digital timer with auto shutoff capability

Temperature Capability

Temperature controllable between 0 to 180 degrees Fahrenheit

5. CONTRACTUAL REQUIREMENTS:

5.1. Delivery

The contractor shall deliver, without charge, the equipment to the following address located at Hill Air Force Base no sooner than August 24, 2015 and no later than September 14, 2015:

OO-ALC/MXSG

5909 Southgate Dr.

Bldg. 214 Hill AFB, Utah 84056 ATTN: Taylor Gittins or Gregory Wescott

5.1.1. Technical Data shall include operation and instruction manual

6. WARRANTY:

The contractor shall provide, without charge, 12 months parts and labor warranty with option to purchase additional years’ warranty.

Also requesting the option to purchase up to four years of extended parts and labor warranty and maintenance and repair.

7. SECURITY REQUIREMENTS

The contractors coming onsite once or twice within the year will only require a one day visitor pass or weekly pass. The contractor shall contact GR two days ahead of time letting him/her know the day of the visit. The sponsor is authorized to arrange visit authorization through Pass and Identification (ID) office. Pass and ID office is located near Southgate Entrance, Phone: 801-777-8631 Office Hours:

0700-1630. The contractor shall be a U.S. Citizen. Proof of ID required: Driver’s license. If driving on base, the contractor shall supply Gate Security with proof of drivers’ insurance and registration. The sponsor shall be responsible to escort the contractor while on base.