INSTALL FLOORING NSWG4 TACTICAL ATHLETE TRAINING AREA.docx

INSTALL FLOORING NSWG4 TACTICAL ATHLETE TRAINING AREA

Naval Special Warfare Group Four 2220 Schofield Rd Virginia Beach, VA 23459

A. SCOPE

The Contractor shall provide the technical services, labor and material for the site preparation and modifications to the NSWG4 Tactical Athlete Training Area located at the NSWG4 Headquarter building on the Joint Expeditionary Base in Virginia Beach, Virginia. The following is a brief statement of the work to be accomplished.

1. Flooring:

a. Existing floor is a combination of concrete deck, carpet (adhesive) and poured terrazzo.

Floor preperation will be required per flooring installation specifications.

i. Rubber Floor Prep: Floor prep may be necessary for the proper installation and if needed, will be included in the proposed cost of your flooring installation. Minor Repair, such as filling cracks, minimal surface damage and minor divots is included in typical installation floor prep.

ii. Turf Floor Prep - removal of carpet and Terrazzo flooring will be coordinated through NSWG4.

b. New flooring will cover a total area (NSWG4 BLDG 108 1st Floor) of approximately

6330-SF.

c. Flooring in Area A('Turf Area-see drawing"), approximately 60' x 24' for a total of 1440-SF (See drawing for layout shall be SP125 Blended (polyethylene and nylon blend) Turf 5/8" (+/-1/8") Pile with Dual Polypropylene primary backing, 5mm Polyurethane Foam with Scrim as secondary backing. Total weight approximately 124oz per square yard.

i. Minimum 5-year limited warranty from date of production. Warranty provided by manufacturer. ii. Semi-seamless finished product required. This will be a training surface where athletes will perform strength and rehabilitation exercises. Seams presenting an obstacle to performance of exercises are not acceptable. iii. Primary Color: Green. White 4-inch wide lines shall extend the width of the turf on the ends of Area A, and every 10-yards in between. White 4-inch-wide, 2-foot-long hash marks shall mark every 5-yards in between every full-width line. See drawing. iv. Edges of Area A will be capped in commercial-grade T- or Edge-molding as appropriate for longevity of surfaces and to reduce tripping hazard.

d. Flooring Area B (rubberized matted area-see drawing), approximately 4890-SF Total shall be pre-fabricated rubber athletic flooring, molded single layer tile consisting of 100% recycled SBR rubber with waffle bottom design for shock absorption, impact absorption, drainage and cable routing.