F00-872-4142.pdf

NOTE: THE ABOVE POP MARKINGS

ARE FOR DOD USE ONLY.

MUNITION NOTICES

NOTES

1. BOND REF.-3 TO REF.-2 WITH ADHESIVE CONFORMING TO A-A-1936 OR EQUAL. SCORE FOR FOLD ON TWO OF THE

LINERS, REF.-2.

2. ALTERNATE MATERIAL FOR REF.-3, USE 3 THICKNESS OF 200 LB, DW, CONFORMING TO ASTM D4727 CL. DOM, LAMINATED TOGETHER WITH ADHESIVE MMM-A-250 OR EQUAL.

3. PLACE ITEM IN BARRIER BAG, REF.-4, REMOVE AIR AND SEAL CLOSED.

4. BAND CONTAINER CLOSED USING REF.-5.

INTERNATIONAL STANDARDS FOR PHYTOSANITARY MEASURES

REVISION OF ISPM NO. 15

REVISION OF WOOD PACKAGING MATERIAL FOR INTERNATIONAL TRADE

THE FOLLOWING STATEMENT IS IN COMPLIANCE WITH THE UNITED NATIONS-IMPLEMENTED RESTRICTIONS ON WOOD

PACKAGING MATERIAL (WPM). THIS REQUIREMENT IS SPECIFICALLY CONCERNED WITH INVASIVE SPECIES SUCH AS THE

PINEWOOD NEMATODE. WPM IS DEFINED AS WOOD PALLETS, SKIDS, LOAD BOARDS, PALLET COLLARS, WOODEN BOXES, REELS, DUNNAGE, CRATES, FRAMES, AND CLEATS. THE STATEMENT BELOW CITES THE REQUIREMENTS IN DETAIL AND

COVERS LUMBER FOR BUILDING CONTAINERS AND PALLETS USED FOR DELIVERIES, RESULTING IN SHIPMENTS WORLDWIDE

(DIRECT, OR THROUGH AIR LOGISTICS CENTERS (ALC), CONTAINER CONSOLIDATION POINTS (CCP), OR OTHER BASES).

WOODEN LUMBER, WOODEN PALLET AND PACKAGING/CONTAINER STATEMENT:

ALL WOODEN LUMBER, WOODEN PALLETS, AND WOODEN CONTAINERS PRODUCED ENTIRELY OR IN PART OF WOOD

PACKAGING MATERIAL (WPM) SHALL BE CONSTRUCTED FROM DEBARKED WOOD IN ADDITION TO THE APPLICATION OF

HEAT-TREATED (HT) MATERIAL (HT TO 56 DEGREES CENTIGRADE OR 133 DEGREES FAHRENHEIT FOR 30 MINUTES).

CERTIFICATION/MARKING IS REQUIRED BY AN ACCREDITED AGENCY RECOGNIZED BY THE AMERICAN LUMBER STANDARDS

COMMITTEE (ALSC). FOR REFERENCE DOCUMENTATION, SEE LATEST REVISION OF "INTERNATIONAL STANDARDS FOR

PHYTOSANITARY MEASURES (ISPM NO. 15), "REGULATION OF WOOD PACKAGING MATERIAL IN INTERNATIONAL TRADE."

SHOULD BE LOCATED ON FRONT OF

CONTAINER, SEPARATED FROM OTHER

MARKINGS. IF SPACE IS NOT

AVAILABLE, CAN BE ON BACK OR TOP

OF CONTAINER

MARKED ON BOTTOM END.

ONE LOCATION IS REQUIRED.

MARK BOTH ENDS

WITH DODIC AND

LOT#.

(OPTIONAL)

TYPICAL OUTER PACKAGE MARKINGS

2D BAR CODING

IS REQUIRED IAW:

(MIL-STD-129 5.6.5)

(MIL-STD-129, REF. 5.6.1-5.6.2f)

OPTIONAL ON TOP

(IF APPLICABLE)

ATTACHMENT

OPPOSITE OF IDENTIFICATION MARKINGS.