F00-520-3513.pdf

NOTE: THE ABOVE POP MARKINGS

ARE FOR DOD USE ONLY.

MUNITION NOTICES

NOTES

1. WRAP ITEM IN REF.-5, PLACE IN CUSHIONING, REF.-3, INSERT INTO BARRIER BAG, REF.-6, PLACE INTO INTERIOR

CONTAINER, REF.-2, AND SEAL WITH PACKAGING TAPE, REF.-4. PLACE SEALED INTERIOR CONTAINER INTO EXTERIOR

CONTAINER, REF.-1, AND SECURE WITH STEEL STRAPPING, REF.-7.

INTERNATIONAL STANDARDS FOR PHYTOSANITARY MEASURES

REVISION OF ISPM NO. 15

REVISION OF WOOD PACKAGING MATERIAL FOR INTERNATIONAL TRADE

THE FOLLOWING STATEMENT IS IN COMPLIANCE WITH THE UNITED NATIONS-IMPLEMENTED RESTRICTIONS ON WOOD

PACKAGING MATERIAL (WPM). THIS REQUIREMENT IS SPECIFICALLY CONCERNED WITH INVASIVE SPECIES SUCH AS THE

PINEWOOD NEMATODE. WPM IS DEFINED AS WOOD PALLETS, SKIDS, LOAD BOARDS, PALLET COLLARS, WOODEN BOXES, REELS, DUNNAGE, CRATES, FRAMES, AND CLEATS. THE STATEMENT BELOW CITES THE REQUIREMENTS IN DETAIL AND

COVERS LUMBER FOR BUILDING CONTAINERS AND PALLETS USED FOR DELIVERIES, RESULTING IN SHIPMENTS WORLDWIDE

(DIRECT, OR THROUGH AIR LOGISTICS CENTERS (ALC), CONTAINER CONSOLIDATION POINTS (CCP), OR OTHER BASES).

WOODEN LUMBER, WOODEN PALLET AND PACKAGING/CONTAINER STATEMENT:

ALL WOODEN LUMBER, WOODEN PALLETS, AND WOODEN CONTAINERS PRODUCED ENTIRELY OR IN PART OF WOOD

PACKAGING MATERIAL (WPM) SHALL BE CONSTRUCTED FROM DEBARKED WOOD IN ADDITION TO THE APPLICATION OF

HEAT-TREATED (HT) MATERIAL (HT TO 56 DEGREES CENTIGRADE OR 133 DEGREES FAHRENHEIT FOR 30 MINUTES).

CERTIFICATION/MARKING IS REQUIRED BY AN ACCREDITED AGENCY RECOGNIZED BY THE AMERICAN LUMBER STANDARDS

COMMITTEE (ALSC). FOR REFERENCE DOCUMENTATION, SEE LATEST REVISION OF "INTERNATIONAL STANDARDS FOR

PHYTOSANITARY MEASURES (ISPM NO. 15), "REGULATION OF WOOD PACKAGING MATERIAL IN INTERNATIONAL TRADE."

TYPICAL OUTER PACKAGE MARKINGS

FOR REFERENCE USE ONLY. REFER TO MIL-STD-129 FOR

COMPLETE MARKING DETAILS AND REQUIREMENTS.

ATTACHMENT

MARK BOTH ENDS WITH DODIC/NALC

OF THE ITEM BEING PACKED AND THE

APPROPRIATE LOT NUMBER. THE LOT

NUMBER ON THE BOX ENDS SHALL NOT

BE PRECEDED BY THE WORD "LOT" OR

UNDERLINED. MIL-STD-129 5.6.2d

THE LOWER MOST MARKING ON THE

PACKAGE SIDE CONTAINING THE

ITEM NOMENCLATURE SHALL BE

THE AMMUNITION LOT NUMBER.

T H E L O T N U M B E R S H A L L B E

PRECEDED BY THE WORD "LOT" AND

SHALL BE UNDERLINED WITH A

SOLID LINE. MIL-STD-129 5.6.2e

THE APPLICATION OF A 2D (PDF417)

S Y M B O L I S R E Q U I R E D F O R

IDENTIFICATION MARKINGS ON

AM MUNIT IO N A ND EXP LO S IVE

CONTAINERS. MIL-STD-129 5.6.5

& 5 .6 . 5 . 2b ( 1 ) ( 2 ) ( 3 ) ( 4 ) ( 5 ) ( 6 )

POP MARKING FROM

CONTRACTOR TEST

O R D O D T E S T