Wood_Shop_CNC_Router_Amendment_0001.pdf

COMBINED SYNOPSIS/SOLICITATION

FA4620-16-T-A321

AMENDMENT 0001

WOOD SHOP CNC ROUTER

FAIRCHILD AFB

22 SEP 2016

This is a combined synopsis/solicitation for commercial items prepared in accordance with the format in Subpart 12.6, as supplemented with additional information included in this notice.

The purpose of this amendment is to answer questions posed by vendors and extend the quote due date from 22 September 2016 to 22 September 2016 at 5:00 PM Pacific.

Solicitation FA4620-16-T-A321 for CNC Router with 5’x10’ Vacuum Table and installation of 208v three phase outlet at Fairchild AFB. The project will require the delivery and setup of a CNC Router with 5’x10’ vacuum table and installation of a 208v three phase outlet in room 215 on the southwest side for the Fairchild AFB Wood Shop is hereby issued as a Request for Quotation (RFQ).

ITEM

NO

SUPPLIES/

SERVICES

QUANTITY UNIT UNIT PRICE AMOUNT

0001 1 EA

CNC Router

FFP

Contractor is to provide a large 5’x10’ vacuum table CNC router with manuel bit change for woodworking in accordance with attached Salient Characterisitics.

FOB: Destination

SIGNAL CODE: A

NET AMT

ITEM

NO

SUPPLIES/

SERVICES

QUANTITY UNIT UNIT PRICE AMOUNT

0002 1 Lot Install 208v Three-Phase Outlet

FFP

Contractor is to install one (1) 208v, three-phase electrical outlet on the southwest wall of room 215 in the Wood Shop, BLDG 2447B, connected to the service equipment located in room 214A.

FOB: Destination

SIGNAL CODE: A

NET AMT

QUESTIONS AND ANSWERS

Question 1 Does the outlet needing to be installed be directly installed or will conduit have to be ran from the service equipment?

Answer 1 The outlet will have to have conduit ran from the service equipment panel box which is located approximately 150’ from the location of the requested outlet. The conduit will likely require surface mounting on the interior of the building. The service equipment is located in room 214A of building 2447.

Question 2 RFQ does not state the number of tools required. The requirement is for only one tool with a manual tool change or is an automatic tool changer required?

Answer 2 An automatic tool changer is not required. The number of tools required is determined by either the manufacturer’s design or the model of the manuel bit change router used.

The bits required are to be ½” shank bits with carbide blades/edges and consist of the following: (1) 90 degree V bit, (1) 60 degree V bit, (1) ball nose bit, (1) tapered ball nose bit, (1) 1/8” flat tip spiral upcut bit, (1) 1/4” flat tip spiral upcut bit, (1) ½” flat tip spiral upcut bit, and (1) bottom clearing/spoilboard upshear design.

Question 3 The CNC machine itself and the vacuum pump run from two separate circuits and power supplies so that they may work independently of one another. Is this acceptable?

Answer 3 Separate circuits for table and router are authorized as long as all power is ran through one plug capable of running on a 208v three phase outlet. The authorized outlet for installation is a single 208v three phase outlet. Any CNC Router and table shall be capatible with the installed outlet.