1-1 SPECS 075419.doc

IDC Base Roof Repair

DIVISION 9 – FINISHES

SECTION 09900 – PAINTING

PART 1 – GENERAL

1.01 SCOPE: Contractor shall provide all labor, equipment, materials, and perform all work to paint all the new fascia board and all exposed new sheet metal items.

1.02

APPLICABLE PUBLICATIONS:

A. Federal Specifications (Fed Spec):

TT-P-645

Prime Coat for Sheet Metal

TT-E-489

Finish Coat

TT-P-25

Prime Coat for Wood

1.03 SUBMITTALS: Contractor shall submit manufacturer’s descriptive data and samples (Quart Size) for the following items:

A. Prime Coats

B. Finish Coats

PART 2 – PRODUCTS

2.01

MATERIALS:

A. Primer Coat: Primer used for sheet metal items shall be zinc-chromate, alkyd type, in accordance with Federal Specification TT-P-645. Primer used for wood shall be ready mixed, primer, oleoresinous type, in accordance with Federal Specification TT-P-25.

B. Finish Coat: Finish coat used shall be enamel, alkyd, in accordance with Federal Specification TT-E-489. Color used shall match existing building.

PART 3 – EXECUTION

3.01 PREPARATION: The surface on which new paint is to be applied shall be free from ice, frost, moisture, dust, grease, oil, and other foreign materials that may interfere with the painting operation. Galvanized metal shall receive a vinyl-type wash coat conforming to

MIL-P-15328 prior to priming.

3.02 INSTALLATION: All exposed new galvanized sheet metal items shall be primed with one coat of zinc chromate primer and finished with two coats of alkyd enamel. All surfaces of the new fascia board shall be primed with one coat of ready mixed primer and finished with two coats of alkyd enamel.

-- End of Section --

SECTION 09900 PAGE 1