Camper_Numbers_1-3.pdf

U.S. GEOLOGICAL SURVEY

Solicitation for bid to construct a customized camper according to the following:

Water Quality (QW) RV rugged style camper standard equipped. The bottom outside dimensions should be approximately 48-in. wide, 23-in. high, and 96-in. long (no fore or aft wheel well cabinets). The camper shall be in compliance with Federal, State, and local recreational vehicle construction, electrical, gas, and safety codes with the following specifications/options:

• Camper should fit inside of a standard 8 ft bed and not exceed tailgate; additionally, campers should be of standard width and height with a full overhead storage compartment.

• Standard plastic laminate counter top- left and right sides with four overhead cabinet doors on the right side, four on the left, hinges for all doors mounted on the inside (hidden).

• Two drawers, one shallower and one deeper, on each side below the counter top.

• Single basin (non-metallic) enamel coated or composite, located aft, on right side.

• External access to under-basin area.

• Heavy duty connectors to external drain from basin (the current plastic is easily damaged by UV, we would like a more robust alternative if available).

• Standard sliding glass windows with screens, located on each side of the camper.

• One 18,000 BTU, minimum, catalytic furnace, with one 5-gallon L.P. tank with regulator.

• One 26”x72” (or taller) entrance door/screen combination with dead bolt lock.

• Four mounted hydraulic camper jack plates and jack stands.

• Two 120V AC GFCI-protected outlets, inside, one under each overhead cabinet, both left and right sides.

• Two 12V DC outlets, inside, cigarette type, one under each overhead cabinet.

• Four 12V DC LED lights, one under each overhead cabinet, the hallway, and cab-over.

• Two paralleled 12V deep cycle RV batteries installed in the camper with the proper securing straps.

• One solar panel charging system with regulator.

• 1000-watt (minimum) power inverter wired to the camper battery, with shutoff between the battery and inverter, mounted in the left side under-counter cabinet.

• Electrical system wired to operate using internal 12V DC or external 120V AC with 10 gauge wire.

• One half closet, left side by back door, no shelves.

• One refrigerator with icebox on the right side, the largest capacity that will fit in the closet space, switchable running on L.P.G. and electric power.

• Floors of a non-permeable material, overlapping up the sides of the walls for 3 inches and sealed to ensure no liquid materials are allowed to seep into or under any walls or flooring.

• Overhead, reversible electric fan in vent.

• There will be NO need for: mattresses or pads, windows in overhead, gas stove and ventilation hood, air conditioner, window curtains, water tanks and roof access ladder.

140G0321Q0119

Half Closet left side no shelves cabinets

Half closet

Standard width

Standard height