Camper_Number_4.pdf

U.S. GEOLOGICAL SURVEY

Solicitation for bid to construct a customized camper according to the following:

Standard equipped, slid-in 80” x 8 foot camper. The bottom outside dimensions should be 48” wide, 23” high, and 96” long (no fore or aft wheel well cabinets). The camper shall be in compliance with Federal, State, and local recreational vehicle construction, electrical, gas, and safety codes with the following specifications/options:

• Fiberglass exterior.

• Standard width and height with a full overhead storage compartment

• Standard plastic laminate counter top- left and right sides with four overhead cabinet doors on the right side, five on the left, hinges for all doors mounted on the inside (hidden).

• Two drawers, one shallower and one deeper, on each side below the counter top.

• Plastic pull knobs for all drawers and doors.

• Single basin (non-metallic) made of polypropylene or enamel coated, located aft, on both left and right sides

• External access to under-basin area.

• Heavy duty connectors to external drain from basin (the current plastic is easily damaged by UV, we would like a more robust alternative if available).

• Standard sliding glass windows with screens, located on each side of the camper.

• One 5,000 BTU, minimum, catalytic furnace, with one 5-gallon L.P. tank with regulator.

• One entrance door/screen combination with dead bolt lock.

• Four mounted hydraulic camper jack plates, NO JACKS.

• Two 120V AC outlets, inside, one under each overhead cabinet, both left and right sides.

• Two 120V AC outlets, outside, one on each side of camper.

• Six 12V DC outlets, inside, cigarette type, 2 under each overhead cabinet, each side and two in the overhead area, both left and right side.

• Four 12V DC lights, one under each overhead cabinet, the hallway, and cabover.

• Two paralleled 12V 600 amp (+-) deep cycle RV batteries installed in the camper with the proper securing straps.

• Electrical system wired to operate using internal 12V DC or external 120V AC with 10 gauge wire.

• Install camper onto a USGS supplied pickup.

• Floors of a non-permeable material, overlapping up the sides of the walls for 3 inches and sealed to ensure no liquid materials are allowed to seep into or under any walls or flooring.

• Overhead, reversible electric fan in vent.

• There will be NO need for: mattresses or pads, windows in overhead, gas stove, ventilation hood, window curtains, or water tank.

140G0321Q0119

Storage area only

TOP YIIW

D · External U11dtr·hsi11 Access ra111 -......___

Ovtrhud Ca&i11tts Rtfri9tr3tor/

Basin lct&ox

Stora9t Ca&ovtr Coul!ttrtop

Coul!ttrtop Basin

Overhead Ca&i11tts

Ora111 --

140G0321Q0119 adutton Sticky Note Replace fridge with storage area

Liff SIDI ~OM IHSIOI CAMPI!

DQf;;JD□

( Window I ) Coulfttr

I Basin ' 'D I Orawtrs I U11dtr·coulfttr C i11tts

ISttp

Storage

RICH! SIOI IOM IHSIOI THI CAMPIR

G,M,d c,&;,!I ~ D Rtfri9tr3tor/ lct&ox

( Window

I ) Coul!ttl'top

Basin

Sttp l

140G0321Q0119 adutton Sticky Note No fridge, just storage