B08_Att_1_SOW.pdf
PDF 78 KB Posted
- Attached to
- LAKE23-0143 WB HYDROHOIST
- Solicitation number
- 140P8123Q0105
About this file
This document includes a statement of work and specifications for the installation of a floating boat lift at the Willow Beach marina in Arizona. The government seeks a vendor to acquire, deliver, and install a Hydrohoist Ultralift 6600 or equivalent lift with a minimum 6,600 pound capacity in slip E20. The lift must be able to lift v-hull boats between 21 to 24 feet safely above the water without physical exertion in the event of power loss. It will be permanently installed in a 14 foot wide u-shaped slip with 30 amp electric service. The vendor must complete installation within 6 months of the contract award under solicitation number 140P8123Q0105 for the Department of the Interior National Park Service Pacific West Region. Work may only occur Monday through Friday during marina operating hours to avoid holidays.
View the file
Other files
| File | Type | Posted |
|---|---|---|
| Sol_140P8123Q0105_Amd_0001.pdf | ||
| B08_RFQ_140P8123Q0105_0001.pdf | ||
| B03__Att2_SCA_WD.pdf | ||
| Sol_140P8123Q0105.pdf |
On GovTribe
Work with this file
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
Specifications and Statement of Work
Specifications:
- Hydrohoist Ultralift 6600 or equal
- Floating boat lift that uses air to fill pontoons that lift boat completely clear of the water
- Minimum 6,600 lb. boat capacity
- Min. Water Depth, 6.5 ft; Min. Slip Width, 10 ft; Max. Slip Width, 18 ft
-Lift should be simple to operate with a valve control and power switch for the air pump. An additional quick launch pull-up lever is acceptable.
-Lift shall be for v-hull boat – to include 23’ Safeboats, 21’ Boston Whalers, or others.
-Lifted boats may be either inboard jet or outboard propeller driven.
-Boats lifted will be 21 feet to 24 feet in length
-Lift will be installed and permanently attached in a 14 foot wide, u-shaped slip with 30 amp electric service available.
-Lift will have 4 arms, with two on each side of the lift, that permanently secure the lift to the slip and allow for the rise and drop of the lift.
-Lift shall be able to drop the vessel into the water in a controlled manner and without physical exertion in the event electrical power is lost to the lift.
-Lift will be used in an extreme climate where heat exceeds 100 degrees Fahrenheit for over 100 days per year, and over 115 degrees Fahrenheit for at least 60 to 75 days per year.
-Service/repair for the boat lift should be available within a reasonable response area
Statement of Work:
-Vendor will acquire, deliver, and install floating boat lift in one of the Government leased slips at the Willow Beach marina. Willow Beach is a developed area with a marina that is part of the Lake Mead National Recreation Area. The marina facilities are government owned, but concession operated.
Willow Beach is located in Arizona, off of US Highway 93. The access road to Willow Beach is located near milepost 14 on Highway 93 and is approximately a 4 mile drive to the marina from the highway.
-Work can only take place Monday through Friday, avoiding any holidays that may fall on those days.
Work will take place during the marina operating hours.
-Work shall be completed within 6 months of contract award.
-Vendor will be responsible for installation of new lift and removal of all shipping and work materials.
-The slip that the hoist will be installed in is designated E20. It is on the section marina dock that is covered.
File details come from the government source that posted it. Updated .