Attachment C - Example of Crane Removal Plan.pdf

This is Appendix D of a federal contract solicitation document that provides safety requirements and guidance for the installation or removal of equipment, specifically a lifting beam at a facility.

The appendix contains four detailed forms and diagrams that contractors must use to document their actual methods and equipment: (1) Rigging Sketch for Lifting Beam, which requires specification of rigging equipment, attachment methods, center of gravity location, and safety hoist ring torque specifications; (2) Placement of Beam Into Building, which documents the movement of equipment into or from buildings, identifying all interferences and obstacles that could impede placement; (3) Detailed Sequence of Lift, which provides step-by-step procedures for lifting equipment from initial positioning through final placement, including crane boom interference checks, trailer removal, and securing procedures; and (4) Base Ingress/Egress Route, which identifies specific roads, paths, and facility access points needed for transporting large components. The appendix emphasizes that submitted forms must depict the actual methods and equipment to be used, not theoretical approaches. Key safety cautions include prohibitions on using synthetic products, wire rope, or chain for chocking or sweeping; restrictions on tilting items only with chinfalls or ratchet hoist devices; requirements for attaching rigging only to hard attachment points; and mandatory pre-lift review by the on-site Navy Crane Center Representative or Designee. The forms include visual diagrams illustrating proper rigging configuration, beam placement scenarios, lift sequences, and facility traffic routes.