A04-DARbonne_Specification_for_Spray_Boat__motor_and_trailer-_Specifications_.pdf

Attachment I

SPECIFICATIONS

Project: Spray Boat PR Number:2006473

Item: Spray boat

1 Product Features

Name of Item: Aluminum boat and engine

Salient Characteristics:

Aluminum boat 17’ x 54” Trailer to carry 17’ x 54” boat, single axle, aluminum, trailer lights to DMV standards Console in front 24 volt marine battery 3” Half pipe front bumper Funnel with T-rail 4 foot front deck with deck hatch and storage 6 gallon gas tank LED bow light Non-skid full wall to wall floor One Bench seat for driver One pedestal swivel seat and seat base in back Surface-drive, air-cooled 40 horse power v-twin engine with auto and instant reverse long shaft propeller; hydraulic power trim, with gear reduction ratio of 1.52:1 Electric clutch Hydraulic steering Transom tie down straps

Capabilities (if applicable): n/A

2. Delivery

Prices quoted must be FOB Destination

“F.o.b. destination” means --Free of expense to the Government delivered, on board the carrier’s conveyance, at a specified delivery point where the consignee’s facility (plant, warehouse, store, lot, or other location to which shipment can be made) is located; and

Supplies shall be delivered to the destination consignee’s wharf (if destination is a port city and supplies are for export), warehouse unloading platform, or receiving dock, at the expense of the contractor. The Government shall not be liable for any delivery, storage, demurrage, accessorial, or other charges involved before the actual delivery (or “constructive placement” as defined in carrier tariffs) of the supplies to the destination, unless such charges are caused by an act or order of the Government acting in its contractual capacity. If rail carrier is used, supplies shall be delivered to the specified unloading platform of the consignee. If motor carrier (including “piggyback”) is used, supplies shall be delivered to truck tailgate at the unloading platform of the consignee, except when the supplies delivered meet the requirements of Item 568 of the National Motor Freight Classification for “heavy or bulky freight.” When supplies meeting the requirements of the referenced Item 568 are delivered, unloading (including movement to the tailgate) shall be performed by the consignee, with assistance from the truck driver, if requested.

If the contractor uses rail carrier or freight forwarder for less than carload shipments, the contractor shall ensure that the carrier will furnish tailgate delivery when required, if transfer to truck is required to complete delivery to consignee.

Contractor responsibilities. The contractor shall -- (1)(i) Pack and mark the shipment to comply with contract specifications; or

(ii) In the absence of specifications, prepare the shipment in conformance with carrier requirements;

(2) Prepare and distribute commercial bills of lading;

(3) Deliver the shipment in good order and condition to the point of delivery specified in the contract;

(4) Be responsible for any loss of and/or damage to the goods occurring before receipt of the shipment by the consignee at the delivery point specified in the contract;

(5) Furnish a delivery schedule and designate the mode of delivering carrier; and

(6) Pay and bear all charges to the specified point of delivery.

3. Delivery Location:

Product shall be delivered to the following location:

_______11372 Hwy 143 Farmerville, LA 71241_______________

4. Installation:

Prices quoted must include installation. All labor and parts associated with and required for installation are the sole responsibility of the contractor. No assistance or equipment will be provided by the government. Installation shall be completed according to industry standards.

5. Technical Point of Contact (POC):

_______Gypsy Hanks 318-366-9181_______________

6. Delivery Instructions:

No later than three days prior to delivery, please contact the Point of Contact listed above, to arrange a specific time for delivery. Unloading the product is the sole responsibility of the delivery carrier. No labor or equipment will be provided by the government to unload the supplies.

7.0 Customer Specific Delivery requirements N/A

8.0 Installation:

Prices quoted must include installation. All labor and parts associated with and required for installation are the sole responsibility of the contractor. No assistance or equipment will be provided by the government. Installation shall be completed according to industry standards.