FBO_QA_NC_fayett_fy20.pdf

Solicitation #47QMCA20R010 Fayetteville, NC FAQ’s FY20 Page 1 of 1

1. Looking at your bid sheet are we to assume that all vehicles going forward on this contract will have these devices?

Answer: Correct - Starting in FY20 (and each subsequent year) all new GSA Fleet leased vehicles will/should have this technology installed

2. Installation needs to be done by a technician and driven by that installer to get the device to sync. (TECH GRADE NEEDS TO BE A MINIMUM OF A D-TECH)

Answer: No need to drive the vehicle unless it is located in an area without cell coverage (e.g. parking garage). Per installation instructions from Geotab, the ignition only needs to be turned on to power the device for the initial initialization which should only take 30 seconds to 1 minute. There is no need to be a qualified technician to install the devices - they intended to be self-installable.

3. During installation we are required to drive vehicle 10-15 minutes. Most of the new vehicles that we are receiving do not have 10-15 minutes of fuel in them. How do we put fuel back in them so your customer can get to the fuel station? Also, class A trucks will have to be driven by technicians with CDL if these units are installed on them.

Answer: Again, no need to actually drive the vehicles unless the vehicle needs to be relocated to an area that has cell service from an area that does not have cell service.

The relocation area (with cell service) should be the first available on marshaling contractor’s site.