4-2025031 Design-CTH O-Traffic Signals Interconnection Attachment B Controller Spec.pdf

ATTACHMENT B - MINIMUM SPECIFICATIONS FOR TS2 TYPE 1 TRAFFIC

SIGNAL CONTROLLER CABINET & CONTROLLER

General:

Any units not conforming sufficiently to these specifications as outlined below may be rejected and it will be the responsibility of the Contractor to conform to the requirements unless deviations have been cited in the bid and acceptance made on that basis.

Any additions, deletions or variations from the following specifications must be stated.

Reason for variations and deviations must also be stated. These specifications shall be construed as minimum. Should the manufacturer's current published data or specifications exceed these, they shall furnish evidence upon request that the model to be furnished has been commercially available to the trade for a period of not less than one year. Specifications also require that the Contractor furnish descriptive literature, if available, complete specifications, and all other necessary data on the equipment Contractor proposes to furnish. The Contractor shall also furnish a copy of the conditions of vendor's warranty.

The manufacturer must be ISO 9001-2021 Registered and have been certified in the IPC “Class II” Electronics standards and training for all manufacturing staff to ensure manufacturing quality, documentation, and proper going/continuing employee training for manufacturing processes by IPC Certified Trainers.

Controllers are to be the manufacturer's latest model and design.

Location of parts outlet may be used in the evaluation of bid proposals.

Failure to complete all information on questionnaire and bid request form may be cause for rejection of bid.

1. Auxiliary Devices:

a. Controller Unit:

Each controller unit shall be a NEW Econolite Cobalt controller with data key and Ethernet connection.

2. Manufacturing Registration, Testing and Warranty:

a. Testing:

Each controller shall be tested as under signal load.

b. Warranty:

Each controller shall be warranted by the manufacturer against mechanical and electrical defects for a period of 2 years from date of shipment. The manufacturer's warranty shall be supplied in writing with each cabinet and controller. Second party extended warranties are not acceptable.

The warranty shall provide for full repair or replacement, as determined by the department, of the failed item or cabinet system.

Vendor warranty service response times depend on whether or not the department has spare inventory of the failed item. In the event that there is an issue with either the cabinet itself, or a component for which the department does not maintain an inventory, response times after notification by the department shall be 4 hours to have qualified service personnel on site at the intersection.

Any defects shall be corrected by the manufacturer or supplier at no cost to the owner.