36C24918R0399-006.pdf

STRETCHER CHECKLIST

Base

Inspect the cot frame/base

Verify all welds intact, not cracked or broken

Verify no bent, broken or damaged components

Verify all fasteners secure

Verify no excessive damage to X-frame guards; replace if necessary

Cables/Wires

Verify no damage or pinching of wiring harness, cables or lines

Check routing(s) and connection(s), verify no hanging wires

Verify no damaged connectors; replace if necessary

Cylinder

Verify all fasteners are secure

Verify the cylinder is adjusted so the lock nut is tight and the cot stops moving when it hits the dead stops

Inspect for and verify no hydraulic fluid leaks; inspect the fittings and tighten as necessary

Extend cylinder rod completely and wipe down rod with soft cloth and household cleaner

Electronic Controls

Extend cot to raised position, measure and check load height

Verify “jog” function is operating

Verify high speed raise retract is working

Wear and Tear

Verify no bent, broken, or damaged components

Verify no tears, cracks, or damage to the mattress, head section, or litter frame

Verify all fasteners are secure

Verify side rail and safety bar operate and latch properly

Verify head section, backrest, and foot section operate and lock properly

Adjust pneumatic cylinder for full range of motion

Verify all welds intact, not cracked or broken

Verify all warning labels are present and legible

Hydraulics

Inspect motor mount and verify that all fasteners are secure

Verify no hydraulic fluid leaks

Inspect the reservoir and verify that there are no leaks

Inspect hoses and fittings for damage or wear; replace as necessary

Verify the hydraulic velocity fuse

Manual Back-up Release Handle

Verify the manual back-up release handle functions properly

Verify the manual back-up release handle returns to the stowed position

Verify the base extends/retracts smoothly when the manual back-up release handle is engaged

With 100 pounds or more on the cot, verify the cot does not lower when the manual back-up release handle is pulled

Settings

Verify the in-fastener shut-off bracket is configured properly

Verify the cot and fastener fit and function properly

Verify the safety bar engages the vehicle safety hook properly

Switches

Verify there is no damage or wear to either switch

Verify both switches operate correctly; replace if necessary

Wheels

Verify wheels are free of debris

Verify tires are in good condition

Verify all wheels secure, rolling and swiveling properly

Check and adjust optional wheel locks