314_Flagpatch_Rd_Lead_Report[1].pdf

LEAD-BASED PAINT INSPECTION REPORT

314 Flagpatch Road

Loris, South Carolina Asbestos Inspections, LLC Project # 2023-03-205

Performed in general accordance with HUD along with OSHA regulation 29 CFR 1926.62

Assessment Completed by:

Asbestos Inspections, LLC 4686 Pee Dee Highway

Conway, South Carolina 29527

(843) 995-5197

Dawn Schoolcraft

Lead Paint Inspector #LBP-R-I162035-2

Assessment Completed For:

Mr. Sam LoFaso with Horry County Government 1515 Fourth Avenue

Conway, South Carolina 29526

Inspection Completed On – June 8, 2023 Report Prepared On – June 15, 2023

Lead-Based Paint Inspection Report

Project Number – 2023-03-205 June 15, 2023

TABLE OF CONTENTS

Appendix 1-Site Locations Plan and Sample Location Plan Appendix 2-Photographs Appendix 3-Lead-Based Paint Laboratory Results Appendix 4-License

1.0 SIGNATURE PAGE

This report has been performed at the request of Mr. Sam LoFaso with Horry County Government. The inspection was conducted by Mike Schoolcraft with Asbestos Inspections, LLC on June 08, 2023. The report was prepared and reviewed by the undersigned inspector.

Inspection Performed by: License# Signature Date

Mike Schoolcraft LBP- I-I241150-1 Mike Schoolcraft June 08, 2023

Report Prepared by:

Dawn Schoolcraft LBP-R-I162035-2 Dawn Schoolcraft June 15, 2023

Report Reviewed by:

Dawn Schoolcraft LBP-R-I162035-2 Dawn Schoolcraft June 15, 2023

2.0 COVER LETTER

Mr. Sam LoFaso with Horry County Government 1515 Fourth Avenue Conway, South Carolina29526

Subject: Lead-Based Paint Inspection Report 314 Flagpatch Road Loris, South Carolina Asbestos Inspections, LLC Project # 2023-03-205

Asbestos Inspections, LLC has completed a Lead-Based Paint Inspection for the structure located at 314 Flagpatch Road, in Loris, South Carolina. The inspection was completed on June 08, 2023 by a licensed lead paint inspector.

The following report summarizes the project background, assessment procedures, results, and conclusions. The results presented in this report are indicative of conditions during the time of the inspection and of the specific areas outlined. The information provided in this report should not be used as a bidding document and field conditions should be verified. Should suspect paint coated surfaces, not included within this report, be identified or impacted during the destructive activities, samples must be collected and analyzed for lead content.

Disclosure Responsibility: A copy of this summary must be provided to new lessees (tenants), owners and purchasers of this property under Federal Law (24 CFR part 35 and 40 CFR part 745) before they become obligated under a lease or sales contract. The complete report must also be provided to new purchasers and it must be made available to new tenants. Landlords (lessors) and sellers are also required to distribute an educational pamphlet and include standard warning language in their leases or sales contracts to ensure that parents have the information they need to protect their children from lead-based paint hazards.

I appreciate this opportunity to provide my services. Should you have any questions concerning this report, please contact me at (843) 995-5197.

Sincerely, Lead Paint Inspector (License #LBP-R-I162035-2)

3.0 PROJECT INFORMATION

1.1 Scope and Purpose

Mr. Sam LoFaso with Horry County Government requested this inspection for the structure located at 314 Flagpatch Road in Loris, South Carolina. Based on information obtained from you, the structure is scheduled for demolition. The purpose of this assessment was to identify lead-based paint on building components prior to the scheduled demolition.

The inspection was completed in accordance with procedures specified in the Department of Housing and Urban Development (HUD) 1997 Revision that replaces Chapter 7, Lead-Based Paint Inspection along with Occupational Safety and Health Administration (OSHA) Lead in Construction Standard regulation 29 Code of the Federal Regulations (CFR) 1926.62. The representative bulk samples collected were analyzed by a laboratory recognized under the Environmental Protection Agencies (EPA) National Lead Laboratory Accreditation Program (NLLAP).

2.1 Facility Conditions

The subject structure is a 1,092 square feet single-family home with a pitched shingle roof, brick veneer siding, and wood windows. The interior consists of mostly wood panelled walls, drywall ceilings, and flooring ranging between wood, carpet and sheet flooring.

The possibility exists that paint coated surfaces were undetected in inaccessible areas such as, locked rooms, behind exterior veneer, pipe chases, or wall voids. If additional suspect paint coated surfaces not included in this report are discovered during renovation, samples should be collected and analyzed for lead content.

3.1 Lead-Based Paint Assessment Data

The assessment was performed by identifying paint coated surfaces associated with the structure in accordance with HUD guidelines. One paint chip sample was collected for each painted surface of the structure’s building components, which includes but is not limited to shutters, siding, exterior trim, window trim, windowsills, interior and exterior doors, door frames, walls, baseboards, chair rails and floors. The samples collected were approximately 1-4 square inches in size and included all layers of paint, placed inside an appropriate sample container, and labeled accordingly using a unique identification number. A chain of custody was completed for the samples with project specific information and then submitted to Eurofins/CEI for analysis. The samples collected were analyzed via EPA Method SW846 3050B/7000B. The following outlines the paint chip samples collected and analyzed:

Sample # Substrate Component Color Paint Location Condition Lead Concentration (mg/cm2 ) P1 Wood Exterior Door White Back Porch Intact 0.098 P2 Wood Windowsill White Bedroom 2 Intact 0.56 P3 Wood Handicap Ramp Red Handicap Ramp Intact <0.0049

Sample # Substrate Component Color Paint Location Condition Lead Concentration (mg/cm2 ) P4 Wood Windowsill Tan Living Room Intact <0.011 P5 Wood Interior Door Tan Hallway Intact <0.013 P6 Drywall Interior Wall White Bathroom Intact 0.0042 P7 Wood Interior Window White Bathroom Intact <0.0080 P8 Metal Exterior Door White Kitchen Intact <0.0078

Condition Assessment Key

Type of Bldg. Component Total Area of Deteriorated Paint on Each Component

Intact Fair1 Poor2

Exterior components with large surface area

Entire surface area is intact

Less than or equal to 10 square feet

More than 10 square feet

Interior components with large surface area

Entire surface area is intact

Less than or equal to 2 square feet

More than 2 square feet

Interior and exterior components with small surface areas

Entire surface area is intact

Less than or equal to 10% of the total surface area of component

More than 10% of the total surface area or the component

Superscript 1 = surfaces in “fair” condition should be repaired and/or monitored but are not considered to be lead based paint hazards.

Superscript 2 = surfaces in “poor” condition are considered to be lead based paint hazards as defined by Title X and should be addressed through abatement or interim controls.

Site location plan and sample locations are identified as Figures 1 and 2 in Appendix 1 of this report, photographs are in Appendix 2, lead-based paint lab results are in Appendix 3, and licenses are in Appendix 4.

4.1 Conclusions

HUD defines paint as lead-based if an amount greater than 1.0 mg/cm2 or 0.5 percent by weight is identified in a paint chip sample. The results of this inspection indicate that lead in concentrations greater than or equal to 1.0 mg/cm2 or 0.5 percent by weight was identified on the building components sampled and analyzed for the structure located at 314 Flagpatch Road, in Loris, South Carolina:

White Wood Windowsills throughout the home

A copy of this report should be provided to the contractors to assist with compliance with applicable State and Federal regulations. Additionally, this report should be kept by the owner and future owners for the life of the dwelling.

Site Location Plan and Sample Location Plan

Site Location Plan 314 Flagpatch Rd Loris, SC Project # - 2023-03-205

Scale: Not to Scale Reviewed By: DS Date: 6/9/23 Source: N/A

Figure 1

Subject Property

Sample Location Plan 314 Flagpatch Rd Loris, SC Project # - 2023-03-205

Figure 2

LEGEND

Sample Location

Scale: Not to Scale Reviewed By: DS Date: 6/9/23 Source: N/A

Figure 2

LEGEND

Sample Location

Kitchen

P1

P7

Bath Bedroom 3

Bedroom 2Bedroom 1

Living Room

P6

P2

P5

P3

P8

P4

Photographs

Site Photos

Exterior

Bedroom

Bathroom

Living Room

Living Room

Kitchen

Laboratory Results

Asbestos Inspections LLC 4686 Peedee Hwy Conway, SC 29527

06-12-23 06-14-23Analyzed:

LABORATORY REPORT

LEAD IN PAINT

Lab Code: C230779

LAB ID

Received:

CLIENT ID

314 Flagpatch RdProject:

Client:

PPM (µg/g) CONCENTRATION

% BY WEIGHT

Eurofins CEI 730 SE Maynard Road Cary, NC 27511

TEL: 866-481-1412

TEL: 919-481-1413

FAX: 919-481-1442

METHOD: EPA SW846 7000B

06-14-23Reported:

P1 CA3055 0.098980

P2 CA3056 0.565600

P3 CA3057 <0.0049<49

P4 CA3058 <0.011<110

Sample weight below protocol guidelines

P5 CA3059 <0.013<130

Sample weight below protocol guidelines

P6 CA3060 0.004242

P7 CA3061 <0.0080<80

P8 CA3062 <0.0078<78

Page 1730 SE Maynard Road • Cary, NC 27511 • 919.481.1413

METHOD: EPA SW846 7000B

LAB ID

Eurofins CEI 730 SE Maynard Road Cary, NC 27511

TEL: 866-481-1412

TEL: 919-481-1413

FAX: 919-481-1442

Project: 314 Flagpatch Rd

Lab Code: C230779

CLIENT ID PPM (µg/g)

CONCENTRATION

% BY WEIGHT

LEGEND µg = microgram ml = milliliter ppm = parts per million Pb = lead g = grams

Reviewed By:

This method has been validated for sample weights of 0.020g or greater. When samples with a weight of less than that are analyzed those results fall outside of the scope of accreditations.

* The analysis of composite wipe samples as a single samples is not included under AIHA accreditation.

Minimum reporting limit is 10 µg total lead. Sample results denoted with a “less than” (<) sign contain less than 10.0 µg total lead, based on a 40ml sample volume.

REGULATORY

LIMITS

Federal Lead Standard / HUD: 0.5% lead by weight.

wt = weight

Consumer Products Safety Standard: Greater than 0.009% lead by weight.

OSHA Standard: No safe limit.

Lead samples are not analyzed by Eurofins CEI Lead samples are submitted to an AIHA ELLAP accredited laboratory for lead analysis of soil, dust, paint, and TCLP samples.

Laboratory results represent the analysis of samples as submitted by the client. Information regarding sample location, description, area, volume, etc., was provided by the client. Unless notified in writing to return samples, Eurofins CEI discards client samples after 30 days. This report shall not be reproduced, except in full, without the written consent of Eurofins CEI.

Information provided by customer includes customer sample ID, location, volume and area as well as date and time of sampling.

Tianbao Bai, Ph.D.

Laboratory Director

End of Report

Page 2730 SE Maynard Road • Cary, NC 27511 • 919.481.1413

Certifications

12884, 06/30/2023, North Carolina, Dawn Schoolcraft

1909008, 09/30/2023, South Carolina, Dawn

LBP-R-I162035-2, 03/16/2024, South Carolina, Dawn Schoolcraft

BI-00738, 06/06/2023, South Carolina, Dawn