2-B. SPECIFICATIONS.pdf
PDF 119 KB Posted
- Attached to
- TEMPEST POLYMER FEED SYSTEM
- Solicitation number
- RFQ-CA-26-1001
- Issued by
- Pasco County, Florida
About this file
This is a specifications document for RFQ-CA-26-1001 issued by a Florida county for the procurement of one (1) Tempest Polymer Feed System to replace existing equipment at Shady Hills WWTP located at 14220 Hayes Road, Spring Hill, FL 34610. The specifications outline the minimum requirements for the system, including the manufacture part number TPS-600-D4, polymer output capacity of 0.20 to 4.00 gallons per hour, dilution water flow of 60 to 600 gallons per hour, and specific inlet and outlet configurations with electrical specifications for pump control and alarm relay functions. All work must be performed in accordance with applicable state, local, and national laws and codes, as well as manufacturer's installation requirements and recommendations.
Pricing for the bid must be all-inclusive and shall cover labor, tools, materials, equipment, and all delivery and freight costs with Freight on Board (FOB) Destination terms to the specified location. The County reserves the right to award the contract to multiple vendors if determined to be in its best interest, though the intent is to contract with one vendor. All products supplied must include written manufacturer's warranty coverage. The County does not guarantee any quantities mentioned in the solicitation and reserves discretionary authority regarding vendor selection and contract award.
View the file
Other files
| File | Type | Posted |
|---|---|---|
| 3-C. RFQ SIGNATURE FORM.pdf | ||
| 1-A. PO TERMS AND CONDITIONS.pdf |
On GovTribe
Work with this file
- Download the original file
- Contacts named in this file
- Similar government files
- Ask GovTribe AI about this file
Text version
RFQ-CA-26-1001
SPECIFICATIONS
Tempest Polymer Feed System
1. INTRODUCTION
1.1 The intent and purpose of this specification is to contract with a vendor to provide one (1) Tempest Polymer Feed System for direct replacement of existing equipment.
2. GENERAL REQUIREMENTS
2.1 All work must be performed in accordance with all applicable state, local and national laws and codes.
2.2 All quantities stated in this solicitation are estimates for bidding purposes. The
County does not guarantee any quantities mentioned herein.
2.3 All work shall be performed according to the manufacturer’s installation requirements and recommendations and in accordance with all plans and specifications.
2.4 While it is the county’s intent to the contract to one Vendor, we reserve the right to award to multiple Vendors if found to be in our best interest.
2.5 Pricing must include all labor, tools, materials, and equipment needed to complete all services as described herein.
3. MINIMUM REQUIREMENTS
The Tempest Polymer Feed System must include but not limited to the following:
3.1 Manufacture part # TPS-600-D4
3.2 Polymer output: 0.20 to 4.00 gph
3.3 Dilution water flow: 60 to 600 gph
3.4 Inlets: 1’’ NPT (F); ½’’ NPT (F) polymer; 1’’ NPT (F) solution
3.5 Output: pump on/off: SPST (NO) 5A, 120 VAC; alarm relay: SPST (NO) 5A, 120
VAC
3.6 Input: 4-20 mA, on/off
4. DELIVERY
4.1 Delivery will be to the address below:
RFQ-CA-26-1001
Shady Hills WWTP 14220 Hayes Road Spring Hill, FL 34610
4.2 Bid pricing must be inclusive of all delivery costs, freight.
4.3 All items are to be shipped: Freight on Board (FOB) Destination.
5. WARRANTY
5.1 Vendor shall offer written manufactures warranty on all products supplied.
END OF SPECIFICATIONS
File details come from the government source that posted it. Updated .