Shaw Adhesive 5000.pdf

#5000

SPECIFICATION SHEET

DESCRIPTION: 5000 PRESSURE SENSITIVE ADHESIVE

is a versatile, water-based, clear acrylic co-polymer adhesive that is solvent free, low odor, contains no hazardous chemicals, and meets the CRI Green Label criteria. Used “Dry” it is a releasable and rebondable adhesive for carpet tiles. #5000 adhesive may be applied to porous or non-porous surfaces and should be allowed to dry completely. Adhesive will be tacky but will not transfer to back of carpet tile. Drying time will vary depending on the temperature, humidity, and porosity of the substrate This adhesive is not recommended for use over concrete slabs where hydrostatic pressure, excessive moisture or alkali exists. Available in 4-gallon pails.

APPLICATION:

Apply adhesive with a 3/8” foam roller for carpet tile installations. Use a 1/16” x 1/16” x 1/16” V notch trowel for 6’ wide carpet. Note: Do not install carpet into wet adhesive as this will result in a permanent bond and may cause carpet to bubble.

PHYSICAL PROPERTIES:

V.O.C.: 0 grams per litre (calculated) Base: Acrylic latex Color: White Solids %: 53% Consistency: Light paste Open time: Several hours Coverage: Up to 150-350 sq. ft. per gallon Shelf Life: Up to one year in unopened container at 70 degrees F Flammability: Non-flammable, qualified for NFPA Class A and UBC Class 1 fire ratings as determined by the ASTM E84 Tunnel Test Clean-Up: Use warm, soapy water while wet. When dried, use WFT #9

Adhesive Remover/Stripper.

Other Features: Freeze-thaw stable to 10 degrees F. Low odor.

CAUTION

Do not take internally. If swallowed, DO NOT induce vomiting. Call a physician immediately.

KEEP OUT OF THE REACH OF CHILDREN. V.O.C. zero grams per liter of material (calculated) non-photochemically reactive per Rule 102.

WARRANTY

This adhesive is manufactured according to exacting quality standards and warranted to be free from manufacturing defects. Defective material called to our attention within one year from manufacture will be replaced. No guarantee, expressed or implied is made regarding the performance of this product since the manner and conditions of application are beyond our control.

Shaw Industries - P.O. Drawer 2128 Dalton, GA 30722 (800) 441-7429

#5000 MATERIAL SAFETY DATA SHEET

SECTION I SECTION II

Manufactured for: Shaw Industries Address/Phone: P.O. Box 2128 Dalton, GA 30722

(909) 360-6677 Emergency Telephone No.: (800) 535-5053 Manufactured by: W.F. Taylor Co., Inc.

Product Class: Synthetic rubber, resin blend Manufacturer's Code Identification: 5000 Trade Name: 5000 Pressure Sensitive Adhesive

Date Revised: 3/18/03

HAZARDOUS INGREDIENTS

None per OSHA Regulation: 29 CFR 1910.1200 SARA Title III Section 313 Chemicals: None

HMIS H=0

F=0 R=0

SECTION III SECTION IV

PHYSICAL DATA

Boiling Point: 212 degrees F

LBS/GAL: 8-9

Evaporation Rate: Same as water Vapor Density: Same as water Vapor Pressure: Same as water Percent Volatile: 47 (by weight) Color: Off-White Odor: Acrylic Grams V.O.C. per liter of material: 0 (calculated) Grams V.O.C. per liter of coating: 0 (calculated)

FIRE AND EXPLOSION HAZARD DATA

DOT Category: Not regulated Flash Point: None

LEL: NA

Extinguishing Media: None required Unusual Fire and Explosion Hazards: None known Special Fire Fighting Procedures: None known

SECTION V SECTION VI

HEALTH HAZARD DATA

SYMPTOMS OF OVER EXPOSURE

Inhalation/Ingestion/Skin: None known Eyes: May cause mild irritation

FIRST AID PROCEDURES

Eyes: Flush with water Skin: Wash with soap and water Inhalation: Remove to fresh air if needed

REACTIVITY DATA

Stability: Stable Conditions to avoid: None known Incompatibility-materials to avoid: None known Hazardous decomposition products: None known Hazardous polymerization: Will not occur

SECTION VII SECTION VIII

SPILL OR LEAK PROCEDURES

STEPS TO BE TAKEN IN CASE MATERIAL IS

SPILLED Use absorbent material to collect and contain for salvage or disposal. Waste disposal: Abide by all state, federal and local regulations.

SPECIAL PROTECTION INFORMATION

Respiratory protection: None should be needed Ventilation: Local exhaust Protective gloves: None required Eyes: Goggles Other protective equipment: None

SECTION IX

SPECIAL PRECAUTIONS

Precaution for handling and storing: Do not puncture. KEEP OUT OF REACH OF CHILDREN