02_ENGINEERING_DATA_REQUIREMENTS_Attachment_A.pdf

REV: ENGINEERING DATA REQUIREMENTS

(ATTACHMENT “A”)

NOTE: MILITARY SPECIFICATIONS / STANDARDS WILL NOT BE FURNISHED IN THE BID SET.

1.THE FOLLOWING INSTRUCTIONS ARE FURNISHED FOR THE MANUFACTURE OF:

CABLE ASSEMBLY,SPECIAL PURPOSE,ELECTRICAL

2. PART NUMBER:

3107632P002

3. NATIONAL STOCK NUMBER:

6150-01-555-9768

PREPARED BY:

Tim Lucas

OFFICE SYMBOL:

416 SCMS / GUEAA

DATE:

16 May 2018

HILL AFB FORM 462 Page 1 of 1

4. Deviations from specifications identified in drawings or this document are not authorized without prior approval by 416 SCMS/GUEAA Engineering.

5. IUID (Item Unique Identifier) requirements and expectations which the contractor must ensure are complied with.

a. Contractors drawings shall be changed or supplemented by contractor for IUID compliance.

b. Label shall contain all data on existing label, (if existing label is to be replaced), only delete existing label with government engineering permission.

c. Use HRI (Human Readable) and Machine Readable Matrix. (USAF not equipped to read barcode).

d. IUID Matrix needs to be highly visible, in a location easily accessible.

e. IUID marking must be permanent.

f. MIL-STD-130, ISO 15434, ISO 15415, and ISO 15418, (Part Marking as per MIL-STD-130 in lieu of FPS-3008)

i. IUID marking specifications.

1. Minimum 1/8 inch lettering on Human readable to include:

a. Cage (17V)

b. P/N (1P)

c. Serial Number (IS)

2. Minimum 1/4 inch square on Machine Readable 2D Matrix -construct 2 - to include

a. Cage (17V)

b. P/N (1P)

c. Serial Number (IS)

6. Part Marking as per MIL-STD-130 in lieu of FPS-3008.