01 - Specifications Mechanical Maintenance - Cresson.pdf

-1-

CRESSON ACID MINE DRAINAGE TREATMENT PLANT

SPECIFICATIONS

MECHANICAL MAINTENANCE

I. SCOPE OF WORK:

This agreement is for furnishing all necessary labor and material, on an “on-call” basis, to maintain the mechanical equipment at the Cresson Acid Mine Drainage (AMD)

Treatment Plant located at 476 Cresson Shaft Road, Cresson, PA 16630 and three (3)

Pump Station Facilities located in Cambria and Blair Counties, in accordance with the terms of this Invitation for Bid. The location of the Cresson AMD Treatment plant and the pump station facilities can be found in Attachment A.

Questions regarding the technical aspects of this bid should be directed to

Craig Treese, P.E., AMD Operations Unit, at 814-472-1845. Questions regarding the bidding or contracting procedures should be directed to Jeannine Estok at 814-472-1806.

II. CONTRACT TASKS:

When so requested, the Contractor shall provide service within twenty-four (24) hours, unless notified that an emergency exists which requires immediate attention to keep the facility in operation. In the event of an emergency, service shall be provided within three (3) hours.

Examples of services and equipment that may be required under this contract include, but not limited to the following: Specialized services and equipment are needed to repair or modify any treatment plant piping or pipelines and to repair drive motors, diaphragm and peristaltic chemical feed pumps, progressive cavity pumps, centrifugal sludge pumps, submersible pumps, vertical turbine pumps and motors, hydrated lime volumetric and polymer screw feeder, lime slurry clamp mount impeller mixer, polymer mixer, centrifugal blowers, ultrasonic transmitter for level gage of sludge/fluids and hot water heaters.

The Contractor shall provide non-emergency and emergency type service to keep all mechanical equipment in operation. If non-emergency service is not provided within twenty-four (24) hours after direct verbal or telephone notification from the

Commonwealth, or if emergency service is not provided within three (3) hours after direct verbal or telephone notification from the Commonwealth, the Commonwealth has the right to secure the same service from another source and the Contractor shall pay to the Commonwealth all expenses incurred over the unit prices bid. A major plant shutdown defined by the plant supervisor shall constitute an emergency service request.

If emergency service is required during normal work hours on a Holiday, Premium Labor

Rates can be used. Holidays shall consist of the following seven (7) days being New

Year’s Day, Memorial Day, Independence Day, Labor Day, Veterans Day, Thanksgiving

Day, and Christmas Day and shall be the day that the holiday is observed.

-2-

The Contractor hereby convenants, contracts, and agrees to furnish all necessary labor, materials, and equipment, and to perform all the work and labor required herein in an expeditious, substantial, and workmanlike manner in accordance with the bid proposal and all pertinent documents found in the agreement.

III. CHANGES TO EQUIPMENT; REPAIR PARTS AND MATERIALS; MILEAGE:

In the event the Commonwealth's equipment is altered, modified, changed or if any equipment is added, moved within the premises, or moved to other premises, this agreement may be modified in writing or terminated.

The charges for labor required at the Contractor’s shop to fabricate or repair parts requested by the Department will be reimbursable, providing the Contractor supplies an estimate of the time required to conduct the shop work and which will not be exceeded without prior approval of the Department. The charges for work performed at the

Contractor’s shop will be paid at the same rates as for work performed at the job site.

For parts and materials, the Department shall reimburse the Contractor for its actual cost for obtaining the parts and materials, and handling and administrative expenses actually and reasonably incurred to obtain the parts and materials. Such handling and administrative expenses are not to exceed ten percent (10%) of the cost of obtaining the parts and materials. Such handling and administrative expenses must be clearly identified as such on invoices submitted for reimbursement.

Payment for mileage shall be reimbursed at the Commonwealth of Pennsylvania rate which is equal to the higher Privately Owned Vehicle (POV) Mileage Reimbursement rate established by the U.S. General Services Administration (GSA) as found in the

Federal Travel Regulation Bulletin at www.gsa.gov. The Contractor shall be paid the current rate effect on the date(s) of travel.

Invoices for mileage should show the actual mileage times the GSA rate in effect on that date. That amount will be entered as the quantity submitted for payment.

Mileage shall be paid on a reimbursement basis for the actual mileage to and from the work site for an amount not to exceed two hundred (200) miles round trip per service to the Plant/Facility.

The maximum amounts for mileage, as set forth in the Contract, shall not be exceeded without prior written approval of the Commonwealth.

IV. INSURANCE REQUIREMENTS:

The Contractor shall purchase and maintain at its expense the following types of insurances, issued by companies acceptable to the Commonwealth.

http://www.gsa.gov/

-3-

1. Workmen’s Compensation Insurance sufficient to cover all of the employees of the Contractor working to fulfill this Contract.

2. Comprehensive General Liability Insurance, including bodily injury and property damage insurance, to protect the Commonwealth and the contractor from claims arising out of the performance of the contract. The amount of bodily injury insurance shall not be less than $500,000 for injury or death of persons per occurrence. The amount of property damage insurance shall not be less than

$500,000 per occurrence.

3. Automotive Liability Insurance, including bodily injury and property damage insurance, to protect the Commonwealth and the contractor from claims arising out of the performance of the contract. The amount of bodily injury insurance shall not be less than $500,000 for injury or death of persons per occurrence. The amount of property damage insurance shall not be less than $500,000 per occurrence.

The required insurances shall be of the Contractual Liability type and the named insured party shall include the Commonwealth of Pennsylvania. The insurance shall not contain any endorsements or any other form designed to limit and restrict any action by the

Commonwealth, as an additional insured, against the insurance coverage in regard to the work performed by the Contractor. Prior to the commencement of work under this

Contract, the Contractor must provide the Commonwealth with current Certificates of

Insurance. These Certificates shall contain a provision that coverage afforded under the policy shall not be cancelled or changed until at least thirty (30) days written notice has been given to the Commonwealth.

V. BID AWARD:

Bid award shall be to the lowest responsive and responsible bidder meeting all requirements and in accordance with Attachment B, Bid Award. Bidder must bid on all line items and shall complete Attachment B, Bid Award and electronically attach it to the bid submission via www.emarketplace.state.pa.us.

DEP is not responsible for the maintenance of the eMarketplace website.

The Department of General Services Supplier Service Center is available to assist vendors with registration, bidding and account management. For questions regarding registration help, send an email to RA-PSC_Supplier_Requests@pa.gov or call

(877) 435-7363, choose Option 1. For questions regarding bidding help, send an email to srmhelp@pa.gov or call (877) 435-7363, choose Option 2.

DEP is not responsible for the support or functionality of any DGS website.

All bids shall be submitted electronically ONLY before closing date and time.

http://www.emarketplace.state.pa.us/ mailto:RA-PSC_Supplier_Requests@pa.gov mailto:srmhelp@pa.gov

-4-

Bid closing date and time: 2:00 p.m. Thursday, February 26, 2026.

VI. CONTRACTOR QUALIFICATIONS:

After bid opening and prior to award, the Contractor shall provide documentation of experience in providing the specified services in the scope of work. The Department reserves the right to review this documentation and request three (3) references to verify

Contractor’s experience and qualifications.

VII. CONTRACT QUANTITIES:

The quantities are estimated only and may increase or decrease depending upon the needs of the Department. The Contractor shall be reimbursed at the unit price bid for actual work performed.

VIII. CONTRACT TERM:

The Contract shall commence on July 1, 2026, and terminate June 30, 2028. Further, the parties hereto may agree to renew this agreement for up to three (3) additional one (1) year terms, with a final termination date of June 30, 2031, upon the same terms and conditions herein. The Department will give the Contractor at least ninety (90) days written notice of its desire to renew for an additional term. If the Contractor does not wish to renew, he must notify the Department in writing no later than ten (10) days after receipt of the Department’s notice of desire to renew.

The Contractor may increase the contract unit prices by a maximum of three percent

(3%) of the unit price in effect at the time of the renewal term. The Contractor shall give the Department at least ninety (90) days written notice if increases are to be applied.

IX. CONTRACT REQUIREMENTS:

The Contractor shall complete and submit Attachment B – Bid Award.

The Contractor agrees to comply with Attachment C – Steel Products Procurement Act and Trade Practices Act.

The Contractor agrees to comply with Attachment D – Build American, Buy American

Act.

The Contract shall complete and submit Attachment E – Reciprocal Limitations Act.

The Contractor and any subcontractors must agree to comply with Davis Bacon Act

(40 U.S.C. 3141-3144, and 3146-3148) as supplemented by the Department of Labor regulations (29 CFR part 5 entitled “Labor Standards Provisions Applicable to Contracts

Covering Federally Financed and Assisted Construction”).

-5-

X. PAYMENT TERMS:

Payment shall be made on a reimbursement basis. The Contractor shall submit an invoice within thirty (30) days. The Contractor’s representative and the Commonwealth’s representative will compare records of the work performed on each service call and indicate their agreement to the hours of labor and the material furnished by their signatures on the Contractor’s work order. The Contractor shall furnish copies of the work orders involved with each invoice submitted for payment.

The charges for labor shall be for services rendered on the job site and shall include the actual travel time to and from the job site for the mechanic and helper, with travel time being limited to a maximum of two (2) hours per day per person for services.