Shaft Sleeve Machining

The Department of the Navy Naval Sea Systems Command seeks machining services to rough machine 70/30 copper-nickel shaft sleeves after casting. The contractor will be required to machine the shaft sleeves to specified dimensions and tolerances, achieving a minimum 250 RMS surface finish. The contractor must inspect each sleeve and record casting numbers, heat treatment information, and vibro-etching identification marks. Dimensions must then be measured and recorded in accordance with the provided data requirements specifications. Proposals are due by February 20, 2024 and will be evaluated based on the offeror's technical approach, past performance, and price.

This requirement has been set aside for total small business participation. The predominate NAICS code is 332710 and PSC code is 3120. The contractor will machine approximately 70 shaft sleeves over a six month period. Special controls are necessary due to the critical application of these shaft sleeves in naval vessel propulsion systems, and the contractor must demonstrate a capable quality management system.