Outboards for Lock and Dam 5 Lifeboat

LD5 LIFE BOAT OUTBOARD MOTORS

1. Provide (2 ea) 75-100 horsepower fuel injection outboard engines for a life boat with all components

to include but not limited to: wiring harnesses, controls (including ignition, tachometer, system

checks, shift, trim and throttle), control cables, key switches, steering components, and (2 ea)

propellers. Both units are to be equipped with power tilt and trim. Engines shall have audible alarms

to indicate low oil or overheating. Engine shaft length shall fit a 25" transom. Propellers shall be

stainless steel and the proper diameter and pitch for the motor. The length of cables and harness shall

be sized to fit the boat. Steering shall be dual control and include all hardware kits and controls.

2. Motor emissions rating shall meet or exceed CARB 3 star.

3. An authorized service center must be available within a 60 mile radius from Winona, MN.

4. Contractor must also provide and include any and all warranties, service manuals, operator manuals

and supporting documentation.

5. The government will deliver the life boat to an authorized service center within a 60 mile radius from

Winona, MN for installation of the motors. Vendors outside a 60mile radius must make arrangements

for transportation of the boat at no additional expense to the Government. The date and time of

Installation shall be coordinated with Dave Tropple, Lock and Dam 5 Lockmaster, 507-689-2101.

6. The motors must be installed by 1 March 2013.