Binghamton Local Flood Protection Project

Added: Oct 14, 2014 3:46 pm Saw cut, remove, prepare and replace approximately 500 cubic feet of deteriorated flood channel downstream of the Conklin Ave. bridge. (see map)Repairs are to be done from channel wall to lower invert section (see photos). Areas to be repaired will be clearly marked with orange marking paint.

2. Materials resulting from demolition work, except as indicated otherwise, shall become the property of the Contractor and be removed daily from the site, unless otherwise approved. Do not allow accumulations. Blasting shall not be allowed on the project. Removal by impact equipment is allowable, with the restrictions noted below.

When removing total wall section down to a noted limit, the impact equipment shall not exceed 150 foot-pounds. When removing wall surface areas only, the Contractor shall saw cut the perimeter of the repair area to a depth of two inches and remove concrete as required using maximum 20 pound chipping hammers and then either hydro blasting with maximum 3,000 psi hose pressure or sand blasting and washing with water.