Afto 350 repairable item processing tag
Cancelled Solicitation Posted
- Solicitation number
- 547519R1
- Agency
-
Government Publishing Office
- Responses due
- Set-aside
- No set-aside
Opportunity facts
- NAICS code
- 323111 Commercial Printing (except Screen and Books)
- Points of contact
Notice details come from SAM.gov. Updated .
About this opportunity
The Government Publishing Office is seeking to procure the printing, numbering, and shipping of 3,000,002 AFTO 350 Repairable Item Processing Tags. The tags must meet specific quality and construction requirements, including printing in black ink on both sides, drilling a hole, reinforcing with a hard fiber patch, and numbering each tag with a 6-digit number. The tags will be evaluated based on the Quality Assurance Through Attributes (GPO Publication 310.1) standard. Proposals are due by September 20, 2024.
This is an unrestricted solicitation, with no set-aside designation. The place of performance is not specified. The total quantity of 3,000,002 tags includes 2 samples, and the tags must be numbered sequentially from 000003 through 3,000,002, excluding any numbers ending in 000.
Notice text
PRODUCT: This specification is for proofing, printing, numbering, corner cutting, drilling, packing, and shipping of tags
TITLE: AFTO 350 REPAIRABLE ITEM PROCESSING TAG
QUALITY LEVEL: III Quality Assurance Through Attributes (GPO Publication 310.1, effective May 1979 (Rev. 09-19)) applies.
QUANTITY: 3,000,002
TRIM SIZE: 3-1/4 x 7-1/2"
DESCRIPTION:
PRINTING: Tag prints face and back in black ink, consisting of text and lines. Printed tags must provide clean, dense, and legible type matter. An approximate 5/16 x 15/16 screened area will print at the bottom of back side of tag; screened area is to remain open and not fill in. Print head-to-head.
CONSTRUCTION: Drill/punch one round hole; 1/4" in diameter, centered on the top 3-1/4" Dimension, center of hole 3/16" from top of tag. Reinforce both sides of tag with a hard fiber patch. No metal eyelet or stringing required. Corner Cut: Clip both corners with diagonal cuts at the top left and right (patch end).
NUMBERING: Number each tag on the face side in two (2) places (same 6-digit number in each place), parallel to the 3-1/4" way, in the TAG NO. areas. Number from 0000003 through and including 3000002 & use 0000001-0000002 For Samples only – (See Distribution) repeating the sequence until the entire quantity is accomplished. DO NOT INCLUDE ANY NUMBERS THAT END IN 000 (three zeroes). Numbers to be 3/16 -l/4" high. The number at the bottom of the tag must be placed one-sixth (l/6") from bottom edge of tag to ensure visibility in file utilized; the corresponding number should also be placed l/6" up from the perforation. Numbering is to be in black ink. There are to be no missing numbers other than the ending 000 numbers.
PERFORATION: Perforate each tag the full 3-1/4'' way) approximately 2" from bottom. The perforation
is to align with the rule just above the text for item 16. SUPPLY DOCUMENT NUMBER on face side of
tag and just above the text for item 29 on the back side of tag.
On GovTribe
Work this opportunity
- Track it in your pipeline
- Find teaming partners
- Similar opportunities
- Ask GovTribe AI about this opportunity