Wage_Determination.pdf

11/10/22, 2:59 PM SAM.gov https://sam.gov/wage-determination/2010-0147/17 1/6

"REGISTER OF WAGE DETERMINATIONS UNDER | U.S. DEPARTMENT OF LABOR

THE SERVICE CONTRACT ACT | EMPLOYMENT STANDARDS ADMINISTRATION

By direction of the Secretary of Labor | WAGE AND HOUR DIVISION

| WASHINGTON D.C. 20210

| Wage Determination No.: 2010-0147 Daniel W. Simms Division of | Revision No.: 17 Director Wage Determinations| Date Of Last Revision: 07/05/2022

Note: Contracts subject to the Service Contract Act are generally required to pay at least the applicable minimum wage rate required under Executive Order 14026 or Executive Order 13658.

|If the contract is entered into on or |With certain exceptions Executive Order | |after January 30 2022 or the |14026 applies to the contract. | |contract is renewed or extended (e.g. |The contractor must pay all covered workers | |an option is exercised) on or after |at least $15.00 per hour (or the applicable | |January 30 2022: |wage rate listed on this wage determination| | |if it is higher) for all hours spent | | |performing on the contract in 2022. | |If the contract was awarded on or |With certain exceptions Executive Order | |between January 1 2015 and January 29|13658 applies to the contract. | |2022 and the contract is not renewed |The contractor must pay all covered workers | |or extended on or after January 30 |at least $11.25 per hour (or the applicable | |2022: |wage rate listed on this wage determination| | |if it is higher) for all hours spent | | |performing on the contract in 2022. |

The applicable Executive Order minimum wage rate will be adjusted annually. Additional information on contractor requirements and worker protections under the Executive Orders is available at https://www.dol.gov/agencies/whd/government-contracts.

NATIONWIDE: This wage determination applies to the United States East Gulf and West Coasts **Fringe Benefits Required Follow the Occupational Listing**

Employed on contract for operation and maintenance of deep sea vessels in the above locality (based on Union Dominance (Seafarers International Union):

UNLICENSED EMPLOYEES:

OCCUPATION CODE - TITLE FOOTNOTE RATE

47010 - Boatswains Freight 195.65 Daily Tanker 186.34 Daily 47020 - Chief Cook/Steward Chief Cook - Freight 153.81 Daily Chief Cook - Tanker 146.54 Daily Steward Assistant - Freight 102.18 Daily Steward Assistant - Tanker 93.53 Daily Steward/Baker - Freight 195.65 Daily Steward/Baker - Tanker 186.34 Daily 47050 - Electrician 209.32 Daily 47060 - Engine Utilityman General Utility Deck/Engine - Freight 122.38 Daily https://sam.gov/wage-determination/2010-0147/17 2/6

General Utility Deck/Engine - Tanker 113.10 Daily QMED (Unlicensed Junior Engineers) - 195.65 Daily Freight QMED (Unlicensed Junior Engineers) - 186.34 Daily Tanker 47090 - Oiler/Diesel Oiler Oiler - Freight 131.75 Daily Oiler - Tanker 122.01 Daily 47401 - Seaman Ab Dayworker - Freight 147.13 Daily Ab Dayworker - Tanker 138.64 Daily Able Seaman - Freight 131.75 Daily Able Seaman - Tanker 122.01 Daily Ordinary Seaman - Freight 102.98 Daily Ordinary Seaman - Tanker 96.75 Daily 47801 - Wiper Tanker 112.02 Daily Freight 122.38 Daily

Note: Executive Order (EO) 13706 Establishing Paid Sick Leave for Federal Contractors applies to all contracts subject to the Service Contract Act for which the contract is awarded (and any solicitation was issued) on or after January 1 2017. If this contract is covered by the EO the contractor must provide employees with 1 hour of paid sick leave for every 30 hours they work up to 56 hours of paid sick leave each year. Employees must be permitted to use paid sick leave for their own illness injury or other health-related needs including preventive care; to assist a family member (or person who is like family to the employee) who is ill injured or has other health-related needs including preventive care; or for reasons resulting from or to assist a family member (or person who is like family to the employee) who is the victim of domestic violence sexual assault or stalking. Additional information on contractor requirements and worker protections under the EO is available at www.dol.gov/whd/govcontracts.

ALL OCCUPATIONS LISTED ABOVE RECEIVE THE FOLLOWING BENEFITS:

1. Health and Welfare and Pension Contribution: $106.21 per man per day.

2. Paid Vacation: Employer contribution of 58% of the daily base wage per man per day.

3. Holidays: Eleven (11) paid Holidays per year - New Year's Day Martin Luther King Jr.'s Birthday President?s Day Memorial Day Juneteenth National Independence Day Independence Day Labor Day Columbus Day Veterans' Day Thanksgiving Day and Christmas Day.

4. Training and Hiring Fund: $26.50 per man per day.

5. Money Purchase Pension Contribution: Employer contribution of 5% of the daily base wage per man per day.

6. Penalty Rates: The rates specified below shall be paid for following work.

A. Penalty Cargoes Longshore Work Restriction to Ship Removing Soot from the bottom Stack Cleaning Bilges and Oil Spills Steering Engine Room https://sam.gov/wage-determination/2010-0147/17 3/6 and Bow Thruster Room.

OFF WATCH: Monday through Friday Group I $37.23; Group II $25.88 Group III $23.02.

ON WATCH: Saturdays Sundays and Holidays Group I $40.86; Group II $27.94 Group III $21.84.

B. Tank Cleaning:

OFF WATCH: Monday through Friday: Group I $37.28; Group II $25.88; Group III $23.70

ON WATCH: Saturdays Sundays and Holidays: Group I $48.96; Group II $34.26;

Group III $29.67

C. Explosives

When the Unlicensed personnel is required to work explosives at any time they shall be paid for such work in addition to their regular monthly wages at the rate of ten dollars ($10.00) per hour unless a higher rate is specified.

GENERAL NOTE

I. In determining the class of vessel horsepower shall be taken from the Record of the American Bureau of Shipping and admeasurement of tonnage as determined by the U.

S. Coast Guard Marine Inspection Admeasurement Section. Power tonnage is the sum of the gross tons figure added to the horsepower figure.

Classification of Vessels

CLASS SINGLE SCREW POWER TONNAGE

A-4 70

001 AND OVER

A-3 45

001 TO 70000

A-2 35

001 TO 45000

A-1 25 https://sam.gov/wage-determination/2010-0147/17 4/6

001 TO 35000

A 17

001 TO 25000

B 12

001 TO 17000

C

7501 TO 12000

D

5001 TO 7500

E TWIN SCREW LESS THAN 5001

A-4 51

000 AND OVER

A-3 35

001 TO 51000

A-2 28

001 TO 35000

A-1 20

001 TO 28000

A

15001 TO 20000

B

9001 TO 15000

C

5501 TO 9000

D

3501 TO 5500

E

LESS THAN 3501

II. Terms utilized in this wage determination not otherwise defined herein shall have meanings and definitions as utilized in the U.S. Coast Guard Regulations and Policy issued pursuant to Title 46 USC and as published by the U.S. Coast Guard in the following publications and others:

1. 46 CFR Parts 1 10 15 26 35 157 175 185 186 and 187 as published in the U.S. Federal Register.

2. U.S. Coast Guard Commandant Instruction COMDTINST MI6000.3 Marine

Safety Manual Volume III-Marine Industry Personnel.

III. The term ""service employee"" does not include any employee who qualifies as an executive administrative or professional employee as those terms are identified in Regulations Part 541 issued under the Fair Standards Act. (See CFR Part 541.)

IV. Subsistence and Quarters: Subsistence and quarters of equivalent value thereof may not be credited toward the provision of minimum wages and fringe benefits required herein.

V. This wage determination applies to United States East West and Gulf Coasts.

** UNIFORM ALLOWANCE **

If employees are required to wear uniforms in the performance of this contract (either by the terms of the Government contract by the employer by the state or local law etc.) the cost of furnishing such uniforms and maintaining (by laundering or dry cleaning) such uniforms is an expense that may not be borne by an https://sam.gov/wage-determination/2010-0147/17 5/6 employee where such cost reduces the hourly rate below that required by the wage determination. The Department of Labor will accept payment in accordance with the following standards as compliance:

The contractor or subcontractor is required to furnish all employees with an adequate number of uniforms without cost or to reimburse employees for the actual cost of the uniforms. In addition where uniform cleaning and maintenance is made the responsibility of the employee all contractors and subcontractors subject to this wage determination shall (in the absence of a bona fide collective bargaining agreement providing for a different amount or the furnishing of contrary affirmative proof as to the actual cost) reimburse all employees for such cleaning and maintenance at a rate of $3.35 per week (or $.67 cents per day). However in those instances where the uniforms furnished are made of ""wash and wear"" materials may be routinely washed and dried with other personal garments and do not require any special treatment such as dry cleaning daily washing or commercial laundering in order to meet the cleanliness or appearance standards set by the terms of the Government contract by the contractor by law or by the nature of the work there is no requirement that employees be reimbursed for uniform maintenance costs.

** SERVICE CONTRACT ACT DIRECTORY OF OCCUPATIONS **

The duties of employees under job titles listed are those described in the ""Service Contract Act Directory of Occupations"" Fifth Edition (Revision 1) dated September 2015 unless otherwise indicated.

REQUEST FOR AUTHORIZATION OF ADDITIONAL CLASSIFICATION AND WAGE RATE

Standard Form 1444 (SF-1444)

Conformance Process:

The contracting officer shall require that any class of service employee which is not listed herein and which is to be employed under the contract (i.e. the work to be performed is not performed by any classification listed in the wage determination) be classified by the contractor so as to provide a reasonable relationship (i.e. appropriate level of skill comparison) between such unlisted classifications and the classifications listed in the wage determination. Such conformed classes of employees shall be paid the monetary wages and furnished the fringe benefits as are determined (See 29 CFR 4.6(b)(2)(i)). Such conforming procedures shall be initiated by the contractor prior to the performance of contract work by such unlisted class(es) of employees (See 29 CFR 4.6(b)(2)(ii)). The Wage and Hour Division shall make a final determination of conformed classification wage rate and/or fringe benefits which shall be retroactive to the commencement date of the contract (See 29 CFR 4.6(b)(2)(iv)(C)(vi)). When multiple wage determinations are included in a contract a separate SF-1444 should be prepared for each wage determination to which a class(es) is to be conformed.

The process for preparing a conformance request is as follows:

1) When preparing the bid the contractor identifies the need for a conformed occupation(s) and computes a proposed rate(s).

2) After contract award the contractor prepares a written report listing in order the proposed classification title(s) a Federal grade equivalency (FGE) for each proposed classification(s) job description(s) and rationale for proposed wage rate(s) including information regarding the agreement or disagreement of the authorized representative of the employees involved or where there is no authorized representative the employees themselves. This report should be submitted to the contracting officer no later than 30 days after such unlisted class(es) of employees performs any contract work.

3) The contracting officer reviews the proposed action and promptly submits a report of the action together with the agency's recommendations and pertinent information including the position of the contractor and the employees to the Wage https://sam.gov/wage-determination/2010-0147/17 6/6 and Hour Division U.S. Department of Labor for review (See 29 CFR 4.6(b)(2)(ii)).

4) Within 30 days of receipt the Wage and Hour Division approves modifies or disapproves the action via transmittal to the agency contracting officer or notifies the contracting officer that additional time will be required to process the request.

5) The contracting officer transmits the Wage and Hour decision to the contractor.

6) The contractor informs the affected employees.

Information required by the Regulations must be submitted on SF-1444 or bond paper.

When preparing a conformance request the ""Service Contract Act Directory of Occupations"" (the Directory) should be used to compare job definitions to ensure that duties requested are not performed by a classification already listed in the wage determination. Remember it is not the job title but the required tasks that determine whether a class is included in an established wage determination.

Conformances may not be used to artificially split combine or subdivide classifications listed in the wage determination."