8663_Rev_1.pdf

DRAWING REVIEW CHECKLIST

Questions to be answered by Design Engineer:

Y N NA

1. Is there an alternate tool or design that could be used to perform this task?

if yes, please explain what and why not used (i.e., cost, time, etc.).

2. Are cracks, voids, weld seams, or other areas where explosives could accumulate eliminated if it is used in and explosive atmosphere?

3. Are all pinch points eliminated so that neither explosive can be pinched or personnel injured?

4. Is the material specified appropriate for explosive atmosphere if used in this environment?

5. Are all Electrical components properly rated for the type of location where it will be used?

7. Are all commercial components specified for use adequately rated for the type of location where it will be used?

8. Does the item have adequate safety interlocks designed (i.e., two-handed controls, etc.)?

9. Is the item strong enough to perform at 150% of intended use (i.e., weight, pressure, etc.)?

10. Is the item designed with ergonomic considerations (i.e., proper height, ?

repetitive movements, proper gripping, line of sight, strength required to operate?

11. Is the item designed for minimal maintenance and does it provide easy access if maintenance is required?

12. Is the item designed to allow lockout/tag out when maintenance is performed?

13. If required, can the item be decontaminated without destroying its intended use?

14. If required, had adequate special fire protection been built into the design?

15. Has the item been designed to interact with other components within the system?

REMARKS: (To add remarks, click on the "Comment" button at the top of the page.)

Signature

6. Is adequate guarding/shielding designed into the item?

REVISIONS

LTR DESCRIPTION DATE DATE

NOMENCLATURE MATERIAL

TITLE

ITEM

NO.

NO.

REQ'D

BREAK ALL

SHARP EDGES

UNLESS OTHERWISE NOTED, TOLERANCES ARE:

DECIMALS: .XXX .005, .XX .01, .X .1 ANGLES: 30'

FOR DRAWING NO.

CHECKED BY

FABRICATION

SAFETY

APPROVAL

DATE

DATE

DATE

DATE

DRAWN BY

DATE

C SCALE DWG. NO. SHEET

OF

CRANE ARMY AMMUNITION ACTIVITY

ENGINEERING DIVISION

7.06

14.19

21.25

28.31

35.44

15.75

26.75

48.00

24.00

11.25

A ADDED NOTES RJW 3/5/19

NOM. 2" X 4" X 48" LONG

NOM. 1" X 6" X 24" LONG

11 SEE

NOTE

NOTE:

1. NORMAL ACCEPTED FASTENING METHODS TO

BE USED IN CONSTRUCTION OF PALLET.

2. MATERIAL TO BE #2 CONSTRUCTION GRADE

LUMBER OR BETTER.

3. TOLERANCE TO BE .25.

DOES NOT APPLY TO MATERIAL LIST

4. MINIMUM NAIL REQUIREMENT: (9) TOTAL NAILS PER

1 X 6 BOARD. EACH 1 X 6 WILL CONTAIN (3) EACH

(8) PENNY RING SHANK NAILS ON 1 X 6 AND 2 X 4

JOINT. 1/4 8663 1 1

PALLET FOR DEMO AREA

11/17/99

RJ WILSON

4 NOV 1999