ACE Trailer SOR 9_2_2021.docx

Statement of Requirement (SOR)

Amendment 1, Dated 9/2/2021

Mobile Support Trailer

1. General Information

New requirement for Mobile Enclosed trailer to support maintenance operations. All plant, labor, supervision, materials, tools, equipment, incidentals, supervision, and management necessary to provide the identified products in Paragraph 1 to the 187th Fighter Wing located in Montgomery, Alabama. Trailer will serve as a mobile support section to ensure mission capabilities are met regardless of the location that the mission is taking place.

1.1. CLIN0001: Qty 1, Enclosed Transportable Trailer

1.2. Specifications:

32ft long by 8.5ft wide by 7ft high Enclosed Trailer (exterior dimensions) Minimum 4 each D ring tie downs externally, 1 on each corner, 10K load minimum 9capacity for each D-ring Insulated ceiling & floors Wall & roof studs Cannot exceed 7ft interior height Minimum 4,500 lb. capacity rear ramp Rear door opening the width of the trailer Ramp & ramp flap with protective surfaces for wear and tear.

Dual cable ramp assist Minimum 1- Led interior light Minimum 36" RV side door Aluminum fenders Electric brakes on both axles 2000 lb. tongue jack Minimum 1- Roof vent License Plate box or bracket Uses 2- 5/16” ball Applicable Safety chains 7 way round plug, flat pins for lighting Breakaway switch & batt.

Minimum 5 year manufacturer warranty Minimum 2- 7000 Torsion-16” 235 -8 lug 10 ply E-8 on 6.5 Color, white or equal Flat Front preferred but not required.

Interior: Overhead Cabinets across Front Led Rear Lights: Led Dual Tail Lights Led Rear Lights: Led Backup Lights 12 Volt interior LED Light for work area or equal 12 Volt external LED Light shining over Ramp area 12 Volt external LED Lights shining over side RV door Jacks & Stabilizers: minimum 7000 lb. Drop Leg Tongue Jack D-Rings - Floor and wall minimum 18 Spare Tire - Steel wheel Spare Tire Mount interior: 1 Window - minimum 30" wide x 15" tall w/ horizontal slider and screen Air Conditioner w/ Heat Strip with BTU to heat and cool interior of trailer to Generator package that can support all power requests, within interior Minimum 2 110 Volt - Interior Receptacle: and minimum 2 110 Volt - GFI Receptacle

2. Delivery, Inspection and Acceptance

2.1. Place of Delivery: 187th Fighter Wing, BLDG 1201, 5187 Selma Hwy, Montgomery, AL 36108. Attention TSgt Joshua Snow. Joshua.snow.5@us.af.mil, 334-394-7345

2.2. Inspection and acceptance will occur at time of delivery by a Government representative. A comprehensive bill of lading or delivery receipt shall accompany all deliverables that details, at minimum, all serial numbers associated with the requested trailer and internal equipment.

Warranty

All equipment shall have the standard manufacturer’s warranty. The Contractor shall warranty all items delivered and ensure all items are free from defects in material and workmanship under normal use and service. Additionally, without charge, repair or replace any equipment found to be defective in material or workmanship provided said equipment has been operated within standard procedures and instructions and such defects are not due to abuse, misuse or Acts of God.

Documentation The contractor shall provide all owner’s manuals, service manuals and any other manufacturer documentation that accompanies the purchase of this item. If any equipment installed has its own service and owner’s manual these will also be provided by the contractor. A standard bill of lading or inventory sheet will be provided listing the serial numbers of all serialized assets installed up to and including the trailer itself.