Atch_01,_PWS,_NG-0045-18.pdf

USATA NG-0045-18

Attachment 01

PERFORMANCE WORK STATEMENT

FOR REPAIR AND CALIBRATION OF TEKTRONIX

MODEL DPO 7054 DIGITAL OSCILLOSCOPE

1.0 GENERAL. The U.S. Army Test, Measurement and Diagnostic Equipment Activity (USATA) has a requirement to acquire commercial factory repair and accredited calibration of a Model DPO 7054 Digital Oscilloscope, Serial Number C131386, manufactured by Tektronix, Incorporated. The Oscilloscope is managed by the U.S. Army TMDE Support Center at Tobyhanna Army Depot, PA.

2.0 CONTRACTOR TASKS.

2.1 A preliminary evaluation of the Digital Oscilloscope, Tektronix Model DPO 7054, S/N C131386, indicates that the display fails when powering up the device. Therefore, the contractor shall furnish all labor and materials required to provide diagnosis and repair, to include calibration traceable to NIST standards, returning the unit to manufacturer’s specifications.

2.2 The Contractor shall not provide repair or other services outside the scope of this contract without authorization from the government Contracting Officer identified at page 1 of the contract.

3.0 GOVERNMENT TASKS.

The U.S. Army TMDE Activity, Redstone Arsenal, AL (Acceptance DODAAC: W80RA6) shall be responsible for receiving, inspection and acceptance in DFAS Wide Area Workflow (WAWF) for all units.

4.0 PLACE OF PERFORMANCE. Performance shall take place at the Contractor’s facility.

5.0 PERIOD OF PERFORMANCE. The Contractor complete performance in accordance with Section B of the contract.

6.0 GOVERNMENT-FURNISHED EQUIPMENT. None.

7.0 QUALITY REQUIREMENTS. Not Applicable.

8.0 CONTRACTOR MANPOWER REPORTING REQUIREMENT – SERVICE CONTRACTS.

[NOTICE: THE FOLLOWING IS MANDATORY FOR AWARD OF A GOVERNMENT SERVICE

CONTRACT:]

8.1 Department of the Army requires reporting of all contractor labor hours associated with services, to include calibration and repair, provided to United States Army organizations;

therefore, USATA-NG-0045-18

Attachment 01

8.2 The contractor shall report ALL contractor labor hours (including subcontractor labor hours) required for performance of services provided under this contractor for the U.S. Army TMDE Activity via secure data collection site. The contractor is required to completely fill in all required data fields using the following web address: https://ecmra.mil.

8.3 Reporting inputs will be for the labor executed during the period of performance during each Government fiscal year (FY), which runs October 1 through September 30. While inputs may be reported any time during the FY, all data shall be reported no later than October 31 of each calendar year, beginning with 2018. Contractors may direct questions to the help desk by clicking on “Send an email” which is located under the Help Resources ribbon on the right side of the login page of the applicable Service/Component’s CMR website.

https://ecmra.mil/