Atch_01,_PWS,_NG-0025-18.pdf

USATA-NG-0025-18

Attachment 01

PERFORMANCE WORK STATEMENT

FOR REPAIR AND CALIBRATION OF ANRITSU SIGNAL GENERATOR

1.0 GENERAL. The U.S. Army Test, Measurement and Diagnostic Equipment Activity (USATA) has a requirement to acquire commercial repair and ISO 17025 accredited calibration of a Signal Generator, Model MG3694C, Serial Number 115013, manufactured by the Anritsu Corporation of Morgan Hill, CA.

2.0 CONTRACTOR TASKS.

2.1 A preliminary evaluation of the Anritsu Model MG3694C, S/N 115013, reports that the unit’s reference will not lock on the reference frequency of 100 MHz. Anritsu, as the original equipment manufacturer, is required to provide repair and calibration to the unit based on the preliminary evaluation and provide accredited. This is for a single major repair with parts, labor and calibration.

2.2 The contractor shall replace defective parts, as required, with original equipment manufacturer parts only. The contractor shall apply applicable factory-proprietary software and firmware updates at intervals required by the original equipment manufacturer. The contractor shall strictly comply with turn-around-time to repair as stated in Section B of the contract.

2.3 The contractor shall not provide any repair or other services outside the scope of this contract without authorization from the government Contracting Officer listed at page 1 of the contract. The contractor shall not hold equipment at the contractor’s facility outside of the contract period of performance stated in Section B of the contract without authorization from the Contracting Officer.

3.0 GOVERNMENT TASKS.

3.1 The government shall be responsible for shipment of all units from the USATA facility to the contractor’s facility at government expense. All units shall be shipped to the contractor’s facility not later than 48 hours (excluding weekends and holidays) after receipt of notice of contract award.

3.2 The U.S. Army TMDE Activity, Redstone Arsenal, AL (Acceptance DODAAC:

W80RA6) shall be responsible for receiving, inspection and acceptance in DFAS Wide Area Workflow (WAWF) for the unit.

4.0 PLACE OF PERFORMANCE. All performance shall take place at the Contractor’s facilities.

5.0 PERIOD OF PERFORMANCE. See Section B of contract.

6.0 GOVERNMENT-FURNISHED EQUIPMENT. None.

USATA NG-0025-18

Attachment 01

7.0 QUALITY REQUIREMENTS. Not Applicable.

8.0 CONTRACTOR MANPOWER REPORTING REQUIREMENT – SERVICE

CONTRACTS.

(NOTICE: MANDATORY REQUIREMENT)

8.1 Department of the Army requires reporting of all contractor labor hours associated with services, to include calibration and repair, provided to United States Army organizations; therefore, 82 The contractor shall report ALL contractor labor hours (including subcontractor labor hours) required for performance of services provided under this contractor for the U.S.

Army TMDE Activity via secure data collection site. The contractor is required to completely fill in all required data fields using the following web address:

http://www.cmra.army.mil, and then click on “Department of the Army CMRA” or the icon of the DOD organization that is receiving or benefiting from the contracted services.

8.3 Reporting inputs will be for the labor executed during the period of performance during each Government fiscal year (FY), which runs October 1 through September 30.

While inputs may be reported any time during the FY, all data shall be reported no later than October 31 of each calendar year, beginning with 2018. Contractors may direct questions to the help desk by clicking on “Send an email” which is located under the Help Resources ribbon on the right side of the login page of the applicable Service/Component’s CMR website.

http://www.cmra.army.mil/